G: Steam knob O: Water tank cover
H: Spray & burst of steam button
Filling water:
1. Before filling with water, please pull out the plug first.
2. Set the steam control to the minimum position.
3. Pull down the cover of water filling mouth, and then fill with water.
Press the spray button, and water will spray out from the spray nozzle.
Always keep enough water in the water tank.
Steam ironing:
1. To use steam ironing, turn the steam control to minimum position
and set the temperature control at the ‘…’ or MAX position.
2. When the indicator light goes out, turn the steam control to the
suitable position.
Burst of steam:
Set the temperature control at the ‘…’ or MAX position, then press
down the burst of steam button.
Dry ironing:
Turn the steam control to minimum position, then set the temperature
control to the suitable position.
Self cleaning:
Fill with water, then plug the iron into the mains. Set the temperature
control to the maximum position. About 3 minutes later, press the self clean
button for about 1 minute. Steam and hot water will be sprayed to clean the
steam chamber. For best results use this function once every two weeks.
Anti-drip:
This iron is equipped with a drip stop function: the iron automatically
stops steaming when the temperature is too low to prevent water from
dripping out of the soleplate.
Anti-calc:
The anti-calc function filtrates the minerals from the water to prevent
mineral residue build up in the steam chamber.
Automatic shut off:
If the iron is switched on and not moved for a period of 8 minutes while
standing on its heel,
