reference.
-Check that the voltage rating of the appliance does in fact match that of
your electrical system.
-To protect against risk of electrical shock do not immerse the appliance, cord
or plug in water or other liquid.
-This appliance is intended for adult use. Ensure that this product is not used by
the disabled, children or people unused to its handling.
-This appliance should be stored out of reach of children and/or the disabled.
-Unplug the appliance when not in use and before cleaning.
-Do not touch hot surfaces and avoid contacting moving parts.
-If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualied person in order to avoid a hazard.
-The use of attachments not recommended or sold by the manufacturer may
cause re, electric shock or injury.
-Household appliances are not intended for industrial or commercial use.
-Take special care not to allow the cord to hang over the edge of the table
or counter.
-Keep hands and utensils away from moving blades while processing food to
reduce the risk of severe injury to persons or damage to the food processor.
A scraper may be used but must be used only when the food processor is not
running.
-Blades are sharp. Handle carefully.
-To reduce the risk of injury, never place cutting blades on base without rst
putting jar properly in place.
-Be certain lid is securely locked in place before operation appliance.
-Never feed food by hand.
-Do not attempt to defeat the lid interlock mechanism.
-Always operate blender with lid is place.
-When blending hot liquids, remove center piece of two piece lid.
-SAVE THIS INSTRUCTIONS
Blending :
1.Put the machine on a stable table.
2.Screw on the cross knife base at the bottom of the blender cup or smart cup.
3.Firstly adding an appropriate amount of puried water in the blender cup or
smart cup, then put the vegetables and fruits which have been cut into small
pieces in the blender cup or smart cup, pay attention that the whole mixed
volume can not exceed the “MAX” scale-line position of the cup.
4.Put the cover and lid onto the blending cup, then tighten it clockwise.
5.Plug in the machine into 220-240 voltage.