Ness SCR-TWR Quick start guide
INSTALLATION NOTES
NESS SCR-TWR
Two Way Radio Receiver
Product Part No. 106-304
2
Recommended mode for PIRs.
Also used for Arming/Disarming Ness panels
such as D8/D16 and earlier models - requires
connection of the Inhibit Input (see page 3).
Recommended mode for Arming/Disarming
some third party control panels.
NESS SCR PRODUCT FAMILY
SCR-TWR receiver
SCR+ Receiver
RELAY OUTPUT
INTRODUCTION
+12V
0V
Input
AuX
nO
nC
C
RELAY
LOW
BAtt
pAnIC
tAMp
On/
ALARM
POWER INPUT
3
ON/ALARM
PANIC/TAMPER
received.
AUX
LOW BATT
+12V
0V
Input
AuX
nO
nC
C
RELAY
LOW
BAtt
pAnIC
tAMp
On/
ALARM
+12V
0V
Input
AuX
nO
nC
C
RELAY
LOW
BAtt
pAnIC
tAMp
On/
ALARM
NOTE. The Open Collector outputs require no
programming. They are always active and always
operate in Pulse mode
OPEN COLLECTOR OUTPUTS
INHIBIT INPUT
HOW IT WORKS
4
COMPONENTS
LED DISPLAY OPERATION – OPERATING MODE
See Signal Strength Mode, page 5.
See Signal Strength Hold Mode, page 5.
+12V
0V
Input
AuX
nO
nC
C
RELAY
LOW
BAtt
pAnIC
tAMp
On/
ALARM
5
SIGNAL STRENGTH MODE
See LED Display Operation, page 4.
device.
OPERATION
TWO WAY RADIO FEEDBACK
6
PROGRAMMING
7
MENU NAVIGATOR
PROGRAMMING
device
device.
Program
the relay
View currently enrolled devices
Delete individual devices or delete all devices
Enrol new
devices
=
=
8
AVAILABLE OPTIONS
STEP-BY-STEP
UPPER LEVEL MENU
1
3
4
6
etc
11
etc
9
PROGRAMMING
3 TWR Radio Key
Other devices
ENROLLING DEVICES
PRODUCT NOTES
106-267 TWR Reed Switch operation with this receiver
10
RRELAY MENU STEP-BY-STEP
PROGRAMMING
R1
Program the RELAY TYPE
R3
R4
Program the RELAY OUTPUT CONTROL
R3
R4
R6
11
PROGRAMMING
DELETING ONE DEVICE or DELETING ALL DEVICES
STEP-BY-STEP
1
DELETING ONE DEVICE
etc
DELETING ALL DEVICES
12
SPECIFICATIONS
This manual suits for next models
1
Table of contents
Other Ness Receiver manuals
