Neunaber WET REVERB v5 User manual

WET REVERB v5
USER GUIDE

Thank you for purchasing our product. We really mean it. We hope to earn your trust by delivering a quality
product that inspires you to make great music.
Neunaber products are designed and manufactured in Orange, California USA.
CONNECTIONS
We recommend that this pedal be placed at the end of your chain, after all other eects. If you are using the
overdrive channel of your amplifier, this eect should be placed in the eects loop for best results.
POWER
The power jack accepts a standard (5.5 mm OD x 2.1 mm ID) center-negative pedal power adapter (not
included). The power adapter must be between 9 V and 12 V and capable of supplying 100 mA or more.
INPUT
The input jack (top right) accepts input directly from your instrument, amplifier eects loop output, or other
eect pedals via a standard 1/4” (6.35 mm) phone connector.
OUTPUT
The output jack (top left) supplies output to another eect pedal, an amplifier, or eects loop return via a
standard 1/4” (6.35 mm) phone connector. The buered output is capable of driving long cables. If plugging
into the input of an amp, you should use the low impedance (Lo-Z) input if available.
FOOTSWITCH
The Engage switch selects between engaged and bypassed. The LED lights when the eect is active.
Bypassing the eect does not lower power consumption, because it does not turn o power to the pedal.

PRIMARY CONTROLS
MIX
The Mix knob controls the mix between the dry signal and reverb:
• Full counter-clockwise is 100% dry
• Full clockwise is 100% reverb
• Approximately 3 o’clock is an even mix: half dry/half wet
TONE
The Tone knob controls the tone of the reverb only. The dry signal is not aected. Counter-clockwise is
darker; clockwise is brighter.
DEPTH
The Depth knob controls the length of the reverb tail; or in other words, the size of the acoustic space.
ALTERNATE CONTROLS
These controls are accessed by holding down the Engage footswitch while turning the knob.
EFFECT
The Eect control switches between the popular original Wet™ algorithm and the new W3T™ algorithm (the
same as the algorithm on the Immerse Mk II).
Eect LED color Knob direction
Original Wet blue counter-clockwise
New W3T green clockwise
TRAILS
The bypassed signal may be selected to have trails or not. When Trails is on, the eect signal trails o
naturally after the pedal is bypassed. When o, the eect cuts o immediately when the pedal is bypassed.
The LED will momentarily change color to indicate which bypass mode is selected.
Bypass Mode LED color Knob direction
Trails o magenta counter-clockwise
Trails on cyan clockwise

SPECIFICATIONS
ELECTRICAL
Nominal input level -10 dBV, instrument level
Maximum input level 8 dBV
Input impedance 1M ohm
Output impedance 1k ohm
Level, enabled vs. bypass 0 dB
Frequency response, dry / bypassed 20Hz - 30kHz, +/-1dB
Total harmonic distortion, dry / bypassed 0.01 %
Signal-to-noise ratio, A-weighted
• dry / bypassed
• Enabled, all knobs 50%
116 dB
101 dB
POWER
Input 9-12 V DC, 100 mA
Connector center-negative, 5.5 mm OD x 2.1 mm ID
PHYSICAL
Dimensions 115 mm L, 64 mm W, 46 mm H /
4.6” L, 2.6” W, 1.9” H
Weight 190 g / 6.7 oz
*Specifications subject to change without notice.
At Neunaber, we love to see what you do with your ‘toys’. We encourage you to tag us in your posts, pictures
& videos featuring your Neunaber gear. To stay connected, go ahead and follow us on the channels seen
below. We can’t wait to see what you do!
This product contains no user-serviceable parts.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
California Proposition 65 Warning: This product may contain chemicals known to the State of California to cause cancer, birth defects or other
reproductive harm. While we believe our products are not harmful when used as designed, we provide this warning to comply with
Proposition 65.
© 2014-2020 Neunaber Technology, LLC. All rights reserved. Neunaber® is a registered trademark of Neunaber Technology, LLC. Wet™ and
W3T™ are trademarks of Neunaber Technology, LLC. US Patent #8204240 & China Patent #CN101689840B.