New England Arbors White Raised Planter User manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Pre-Assembled Side Wall Panels with Posts Connected (2)
2. Floor Panels (4)
3. Floor Support (1)
4. Front and Back Wall Panels (2)
5. Shelf Boards (7)
7. Post Caps (4)
8. 5/8”Stainless Steel Screws (12)
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e.shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ for unobstructed assembling.
• You should not need to use excessive force when assembling components.
The 24”x36” White Raised Planter
Please read through before starting assembly.
AS SE MBLY I NS TRU CT ION S
8
1
Not to Scale
1
4
3
2
Ver 3.1/NOV 2012
   
      
     
   
5
6
www.newenglandarbors.com
9. 1 1/2”Stainless Steel Screws (8)
9
6. Shelf Rails (2)
6

The 24”x36” White Raised Planter
4
3
2
2
STEP ONE
Assemble the seven Shelf Boards into the Shelf Rails. Push until the
tabs lock into place. Note the orientation of the two Shelf rails;
ensure the routed holes are on the same side.
Once inserted, the tabs will lock into place.
Lay the Pre-Assembled Side Wall Panel on the floor as shown and
align and insert the shelf from the above step into the routed hole.
Do the same for the Front and Back Wall Panels as shown.
Note: Only one side of the Shelf Rails will bottom out on the post.
This is designed to accomodate the attachment of an extension kit
(sold separately).
Align and insert the second Pre-Assembled Side Wall Panel as
shown.
Stand the planter box up and fasten the shelf rails to the posts using
8 of the 5/8” screws provided through the pre-drilled holes as shown.
1
The 24”x36” White Raised Planter
www.newenglandarbors.com
1
Note: Routed holes location
2
3
4

The 24”x36” White Raised Planter
7
3
6
STEP O N E ( C O N T ’ D )
Fasten the wall panels together using 4 of the 5/8” screws provided
through the pre-drilled holes on the posts as shown.
Fasten the corner brackets to the posts using 8 of the 1 1/2”screws
provided through the pre-drilled holes on the brackets as shown.
5
www.newenglandarbors.com
STEP T WO
5
6
The 24”x36” White Raised Planter
Insert the floor support rail into the front and rear walls as shown.
Note the notch at the ends of the floor support rail.
7

The 24”x36” White Raised Planter
Port Huron MI USA 48060
Toll Free Phone: [phone] Toll Free Fax: [phone]
www.newenglandarbors.com
4
9
STEP T W O ( C O N T ’ D )
Place the four floor panels onto the floor supports as shown.
Note the notches on the one side of the end panels. The notches
are to wrap around the posts.
Pressure fit the Post Caps into place. Push firmly until they snap
into place.
8
www.newenglandarbors.com
9
8
Notch
Notch