Polyteak CHAAR-OTM OTTOMAN User manual

CARE & MAINTENANCE
All you need to clean your PolyTEAK furniture is warm
water and soap. For extra cleaning power, mix 25%
bleach with 75% water. The sanding sponge included
with your product can be used to remove any tough
stain or build up without damaging the PolyTEAK
material.
Need help? Contact Us!
Email: [e-mail]
Phone: [phone]
Monday – Friday, 10 AM – 5 PM PST
PRE-ASSEMBLY PREPARATION:
Each item is made with high-density material, which
protects against cracks, rot and splinters, keeping your
furniture timelessly beautiful, no matter the season.
OUTDOOR STYLE REINVENTED
UV-stabilized material resists color fading. This means
no repainting ever!
Utilizing our tree-free simulated wood helps us do our
part to preserve forests.
Most importantly, it looks and feels just like real wood!
"We'e einventing all-eather outdoor tyle
and e'e ust getting tarted...”
Outdoor Style Reinvented
PRE-ASSEMBLY PREPARATION:
• Please check that all listed parts and hardware are included before beginning assembly.
• Save all packing materials until assembly is completed to avoid accidentally discarding small parts.
• Read through the preparation and assembly instructions in full before beginning assembly.
• Please use CAUTION AND CARE when lifting the product to avoid personal injury and/or damage to
the product.
• For ease of assembly, two adults are recommended. Assembly time is approximately 30 minutes
For assembly video, please
scan QR code

STEP-BY-STEP ASSEMBLY:
4 Hole Panel (1PC)
(A) Step 1: Attach the 4 Hole Panel (A) to both Back
Legs (D) using 4x Screws (G).
J: Allen Wrench (1PC)
Then attach all the 2 Hole Panels (B) to the Back
Legs (D) using 8x Screws (G). Secure all with
Screwdriver (K)
Step 2: Attach the Front Legs (C) to Back Legs (D)
using 2x M6X50 Bolts (F) on each side as pictured.
Secure each with Nut (H) and Washer (I).
Front Legs (2PCS)
(C)
Back Legs (2PCS)
(D)
2 Hole
Panels (4PCS)
(B)
H: Nut (4PCS) I: Washer (4PCS)
K: Screwdriver (1PC) Sanding Sponge for Cleaning
Front Leg Suppot
(1PC)
(E)
A: 4 Hole Panel (1PC) B: 2 Hole Panels (4PCS) C: Front Legs (2PCS) D: Back Legs (2PCS) E: Front Leg Support (1PC)
F: M6X50 2” (6PCS) G: Screws (12PCS)
L: Hand Wrench(1PC)
Step 3: Attach the Front Leg Support (E) between the
Front Legs (C) using M6X50 Bolts (F).
G
G
FF
H
H
I
*IMPORTANT NOTE: DO NOT OVERTIGHTEN THE BOLTS*
Tighten all bolts and screws after assembly is complete.