Anova SS1001-TRI User manual

anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
• #3 Phillips Head Screwdriver
Assembly Instructions
Shade Structure
SS1001-TRI- Shade Structure w/ Overhead Panel, Triangles Design
SS1001-RIP- Shade Structure w/ Overhead Panel, Ripples Design
SS1001-WAV- Shade Structure w/ Overhead Panel, Waves Design
SS1101-CUST- Shade Structure w/ Overhead Panel, Custom Design
COMPONENT PARTS:
ASSEMBLY HARDWARE: All hardware is stainless steel.
(4) Vertical Posts (2) Front Beams (2) Side Beams
(1) Short Frame Tube (6) Overhead Panels(2) Long FrameTubes
(44) 5/16"-18 Flathead
Hex Drive Screws
ASSEMBLY:
Inspect the shipping container contents for damage and to
determine that all components and hardware are present.
1.
2. Lay all parts on a so work surface or on the shipping
packaging to prevent damage to nish.
NOTE: Before assembling the nuts to the bolts, it is
recommended that a light oil or petroleum jelly be applied
to the screw threads.
1

2
3. Stand one Vertical Post upright in the position that will
serve as the front le as you face the structure.Do so with
the L-bracket facing inward toward where the center of the
structure will be as shown to the right.
4. Stand a second vertical post upright inline with the rst.
Space the posts so that the distance between the outside
faces of the posts is the same as the overall width of the
specied structure.
5. Locate a Front Beam and set it atop the two Verical Posts,
with the L-Channel toward the bottom and facing inward.
Align the holes in the Vertical Post's brackets with the
threaded inserts of the Front Beam.
5a. Locate two 5/16"-18 Screws and fasten the Vertical Post's
bracket to the Front Beam's threaded inserts, leaving them
nger-tight. Repeat this process on both ends of the Front
Beam.
Front
Side
5a

3
6. Repeat steps 3-5a to form a mirrored image of the front
section of the structure, as demonstrated to the right.
Space the rear Vertical Posts away from the front by the
specied structure's projection dimension, again measuring
from the outside faces.
7. Locate a Side Beam and place it between the front and back
structures, again aligning the holes of the top brackets with
the threaded inserts of the xed Beams.
8. Repeat steps 7-7a on the opposite side of the structure,
with the result matching the image to the right.
7a. Fix the components together using four 5/16"-18 Screws;
two from above and two from below.
7a

4
9. Locate the Short Frame Tube and attach it to the Front and
Rear Beam using four 5/16"-18 Screws; two at either end.
10. Locate the Long Frame Tubes and attach it to the Side
Beams using eight 5/16"-18 Screws; two at either end of
each of the Long Frame Tubes.
11. Locate one of the Panels and place it above the tube
frame, starting with one of the corners. Bolt in place with
provided hardware and repeat this process until all panels
are installed.
11a. Aer all panels have been secured, tighten all hardware on
the structure.

Manufactured in the U.S. 5
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
Copyright 2021 ANOVA®11/3/2021
12. Secure the structure to the ground using the Engineering-
recommended hardware. All sixteen mounting holes are to
be used to x the structure in place.
Vertical Post
Side Beam
Front Beam
Panel Long Frame Tube
Short Frame Tube
Replacment Parts