Next 786650 APPLE POD User manual

Tools Needed
Helpline
If you have any problems with this product or
require any replacement fittings please contact
Customer Services Tel: [phone]
• Use non-silicone beeswax to maintain the shine.
• Do not rub or scrub the surface when cleaning.
• Do not use furniture polish.
• Use a furniture oil periodically to maintain the finish and prevent the oil from drying out.
• Do not use abrasive cleaning products.
• Any spills should be removed immediately with a soft clean damp cloth.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent
scratching or damage.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if
necessary.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is
found to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• Made in China.
• For general cleaning, periodically dust with a soft cloth.
PRODUCT INFORMATION
• Made from Aluminimum with PU Rattan finish.
• Every effort is made to ensure colour continuity between pieces, however this is a Hand made product, slight
colour variations and markings may occur.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2persons is required to assemble this product.
•All assembly fittings should always be tightened properly.
CARE INSTRUCTIONS
• The maximum load this shelf/these shelves can hold is 120kg.
• Do not use this item if any structual part is broken or missing. (BS EN 747)
786650 APPLE POD
Page 1 of 3

Tools included
Place the Stalk (A) on top of the Top Unit (B) push it in the hole
until it clicks
Place Top Unit (B) on top of Base Unit ( C) and align the holes
and attach together using the Bolts (D) and Nuts (F) Placing
Washers (E) between the unit and the fitting.
Base Unit ( C)
STEP TWO
STEP THREE
STEP ONE
FITTINGS
The Below fittings and Tools are included
PARTS
Wrench x 1
Stalk (A)
Top Unit (B)
Bolt 65mm (D) x 6
Washer (E) x 12
Nut (F) x 6
Page 2 of 3

Next Retail Ltd, Desford Road, Leicester, LE19 4AT
Page 3 of 3