Case Matthew Hilton Cross Sideboard User manual

Cross
Sideboard
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
casefurniture.com
Cross Sideboard – designed by Matthew Hilton
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This unit is manufactured with either oak, black stained oak or walnut.
Craftsmen manufacture this product and there is variety between each unit. This is
because wood is a natural product, with natural colour and grain variations.
The top, side and drawer faces are matched to ensure a consistent aesthetic
throughout
Natural timber is affected by sunlight; this can can the wood colour to darken.
For this reason (especially if placed in direct sunlight) it is recommended that placing
objects in the same position for long periods of time is avoided. This potential colour
adjustment becomes less relevent as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit.
Please only use proprietary furniture polishes or alternatively, warm water with
a diluted mild detergent.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com

2. Remove all packaging. 3. Open door and remove inner carton containing
legs and fittings.
9. Remove shelves and insert shelf supports (I) at
desired height. Re-insert shelves to rest on supports.
4. Loosen boltsin crossbar with Allen key (E) to allow
movement when fitting the legs to each end.
5. Insert dowels (F) into leg and locate into end of
crossbar.
Loosely locate all bolts properly (A,B and washers G).
Fully tighten ALL boltswith Allen key (E).
6. Once legs and crossbar are securely attached,
turn unit onto feet.
NOTE: Turn as shown to prevent doors and
drawers from opening.
If inner door/drawer bumpers (J) are required
to silence closing, simply peel off and apply
to inside face of door/drawer.
7. Attach drawer handles (H) usingscrews (C).
Fully tighten when straight.
8. Attach door handles (H) using screws (D).
Fully tighten when straight.
A x 4
B x 4
C x 6
D x 4
E
A+G
B+G
E
C
H
I
H
D
Foot wedge (K) will correct uneven
floors which can affect accurate
alignment of doors and drawers.
Insert under foot and snap off
excess atthe desired step.
Height of drawers can be adjusted by turning
wheel mechanism found on each drawer slide.
Adjustments
E x 1
F x 4
1. Open top of carton fully and turn upside down.
H x 5
I x 8
J x 5
K x 1
G x 8
Fully adjustable door hinges help to maintain equal
spacing and correct alignment of doors if required.
back
this way up
crossbar
crossbar
REQUIRED
F
Assembly Instructions