3010L Power Controller User’s Manual
8 Rev.1.4
4 Device Description
The 3010L is a Power Controller for LonWorks network in building automation.
Its peripheral scope has been specially designed for the use as switch
controller for device spreading control of applications such as lighting control.
For the use in lighting the 3010L realizes 10 independent output channels with
ten relay output to control conventional switch.
For the use in sensor the 3010L realizes 10 independent input channels with
ten dry contacts for sensor input.
The LonMark object available per channel flexible use of the 3010L;
Furthermore there are several timer functions for the operation by switch
function. The configuration of the lighting control application is effected via a
plug-In.
Of course, the 3010L is also freeing programmable in Neuron C. As a flash
module is used the application can be load via the LonWorks network, making
the 3010L an I/O controller, e.g.
4.1 Hardware Survey
The 3010L disposes of ten output circuit for each. The output circuit can be
controlled individually relay output 8A.
4.2 Operation and Display Elements
The 3010L is fitted with a service button accessible via a small gap on the
front panel (see Figure. 1.1, 3).Activation of the buttons generates a
service-pin message transmitted via the LonWorks network. The
processor status as well as the service-pin status are displayed by the
service LED (figure. 1.1.3), which is on while the service button is activated.
By use the network management function Wink the service LED flashes.
Furthermore the 3010L is fitted with a reset LED (figure. 1.1, 4), displaying
the availability of device occur reset. The LED is connection to an I/O pin
of the Neuron chip processor.
4.3 Connection Pin Assignment
The following tables show the connector pin assignment of the individual
connectors. Connection the 1marking cf. Figure. 1.1 On previously page.
