Nitek EL1500C Owner's manual

Model EL1500C (for use with Coaxial cable)
Includes one ER1500C Receiver
and one ET1543C Transmitter
Installation and
Operation Manual
Introduction
The EL1500 is a system for extending Ethernet & PoE. The EL1500 can be used on new or existing cable and is
designed to greatly extend the distances to which IP cameras and network devices can operate. In addition to network
communication the EL1500 is ideal for PoE applications. It allows all power to flow from the head end for most camera
applications. In unique cases where high power PoE is needed it can inject up to 25 watts of power at the transmitter
end.
NITEK®
De Aar 99
8253 PN Dronten
The Netherlands
Tel: [phone]
E-mail: [email protected]
WWW.NITEK.NET
USA
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: [phone]
Fax: [phone]
E-mail: [email protected]
WWW.NITEK.NET
EUROPE
09292016
TYPE 1 Installation
EL1500 with a PoE Source Switch and IP Cameras
One common installation involves using the ER1500 Receiver to power both the remote transmitter and PoE camera.
The ER1500 can be powered by a PoE switch. Refer to the diagram below when installing. Refer to the PoE power chart
below to determine maximum range for a PoE camera.
LED INDICATORS
Connector LED OFF ON FLASHING
Network
Port
Power No power Power
Good
Link Status No Ethernet
Link
Ethernet Link
Good
Link
Port
PoE Out No PoE
Power Out
PoE Power
Good
10/100 No Link 100Mb 10Mb
681200111
PoE Device Power
RG59 Coax with
20AWG Center*
Distance Power at PoE Port
328ft/100m 15.4 watts
656ft/200m 13.0 watts
984ft/300m 11.3 watts
1312ft/400m 9.3 watts
1640ft/500m 8.0 watts
*Results with 48VDC power to the
Receiver optional Power Port and
using RG59 SBC Type Cable
Note: This installation should be made by a
qualified service person and conform with local
codes.
Reduce risk of fire or electrical shock. Do not
expose this product to rain or moisture.
IEC/UL 60950-1
Patent Pending USA and Europe
Euro Pat App 2779641

TYPE 2 Installation
Install EL1500 with 48VDC External Power Supply
Refer to the diagram below when installing. When installing without a PoE source device, the ER1500 can be powered
directly. The ER1500 will provide power for both the transmitter and PoE camera. Refer to the PoE power chart on page
1 to determine maximum range for a PoE camera.
(Not Included)