Nitek FTS344000S00 User manual

Installation Manual
FTS344000S00 Quad Transmitter
4 Camera Stand Alone Transmitter
Note: This installation should be made by a qualified
service person and conform with local codes.
Reduce risk of fire or electrical shock do
not expose this product to rain or moisture.
Specifications
Video Connection
Connector 75 ohm BNC Socket
Input Impedance 75 ohm terminated
Input Level 1 volt p-p nominal
Frequency Response 10Hz to 5.75MHz
Optical Connection
Connector SC Style
Path Loss 20 dB
Wavelength 1310 / 1550nm
Power Connection
Supply 12 to 24VDC @ 300mA
NITEK®
5410 Newport Drive, Suite 24
Rolling Meadows, IL 60008
PHONE [phone]
FAX [phone]
WWW.NITEK.NET
Installation Instructions
- The fiber receiver is designed to be mounted using the included bracket.
- Always allow for bend radius of optical and electrical cables when installed.
- There are no adjustments required when using this product.
680600113 Rev 02102009
Service Information
There are no user serviceable parts inside the unit. In the event that service is required to this unit please
contact NITEK Technical Support at 800-528-4343.
!
Color Description
Green System Normal
Yellow (RX) Link working, No video at TX
Red (TX) Power on, No video into TX
(RX) Power on, No opto into RX
Power/Video/Opto LED
Color Description
Green Data is Low / Logic 0
Red Data is High / Logic 1 (RS422/485)
Off Data is Tri-state / (High - RS232)
Data LED
FTS344000S00
CH1 CH2
CH3 CH4
Fiber Optic Video Transmission Systems
WWW.NITEK.NET
800-528-4343
NITEK
R
CLASS 1
POWER
12-18 VDC,
300mA, Class 2
-
+
VIDEO CH4
VIDEO CH2
VIDEO CH3
VIDEO CH1
POWER
VIDEO / OPTO
OPTO IN / OUT
CH1 CH2
CH3 CH4
CH1
CH2
CH3
CH4

Typical Installation - FTS344000S00
VIDEO IN
Connect incoming video
to BNC connectors
SC FIBER IN
POWER
SUPPLY
Fiber Optic Video Transmission Systems
WWW.NITEK.NET
800-528-4343
NITEK R
CLASS 1
POWER
12-18 VDC,
300mA, Class 2
-
+
VIDEO CH4
VIDEO CH2
VIDEO CH3
VIDEO CH1
POWER
VIDEO / OPTO
OPTO IN / OUT
CH1 CH2
CH3 CH4
CH1
CH2
CH3
CH4
Color Description
Green System Normal
Yellow (RX) Link working, No video at TX
Red (TX) Power on, No video into TX
(RX) Power on, No opto into RX
Power/Video/Opto LED