
It complies with the WEEE regulation.
A
+
Energy
Tel: 0212 244 84 22-23 Pbx
Showroom:
Bereketzade Mah. Şair Ziya Paşa Cad. No:31/A PK. 34421 Karaköy, Beyoğlu / İstanbul
Tel: 0212 879 03 53
Factory:
Beylikdüzü OSB Mh. Mustafa Kurtoğlu Cd. No.23 (Bakırcılar Demirciler Sanayi Sitesi)
Beylikdüzü / İstanbul
Web: www.noas.com.tr
LED OUTDOOR
DRIVERS
Dear Customer,
This user manual contains the necessary installation information of
the product you have purchased. For your safety and product life,
follow the safety warnings and warranty conditions instructions in the user manual. If you have a
problem with the product, you can contact us via the contact information avaible in the user
manual.
- Do not connect the panel without reading the user manual.
- Cut off the electrical current before assembling the product.
- Do not use the product other than the conditions specified by product protection class..
- Installations of the panel must be carried out by specialists.
- Do not use the product if the power cables are damaged.
- Do not use the product in places where electricity leakage may occur.
- Make sure the product is complete and correctly connected.
- Our products are guaranteed for one-to-one replacement for 2 years.
- In order for the warranty to be valid, the parts must be delivered to the technical services
completely.
- In case the product is defective; Pursuant to Article 11 of the Consumer Protection Law No:6502;
Sanctions are applied to make free repair, to replace the product that cannot be repaired with a new
product.
- Product that are used outside the instructions for use and exposed to user error are not covered by
warranty.
1- Cut off the electrical current before assembling the product.
2- The product is designed to operate at 220-240V and 50-60Hz. Do not operate with a voltage and frequency other
than these values.
3- The protection class (IP) is indicated on the box of the product. It should not be used outside of the ambient and
climatic conditions specified by the protection class.
4- The LED strip meter application of the LED Driver is specified in the table in the assembly diagram.
5- LED Driver is high current protected.
6- After the assembly process is completed, you can turn on the electric current.
USER MANUAL
ASSEMBLY DIAGRAM
ASSEMBLY INSTRUCTIONS
EN
SAFETY & WARNINGS
WARRANTY CONDITIONS
220-240V
50-60Hz
HIGH
PROTECTION
CURRENT
YL31-0036 YL31-0060 YL31-0120 YL31-0150 YL31-0200 YL31-0250 YL31-0300
3 AMPER 5 AMPER 10 AMPER 12.5 AMPER 16.5 AMPER 20 AMPER 25 AMPER
2835 60 LED 7,5 MT 12,5 MT 25 MT 30 MT 40 MT 50 MT 62,5 MT
2835 120 LED 3,5 MT 6 MT 12,5 MT 15 MT 20 MT 25 MT 30 MT
2835 240 LED 2 MT 3 MT 6 MT 8 MT 11 MT 13 MT 16 MT
4040 60 LED 2 MT 4 MT 8 MT 10 MT 13,5 MT 16 MT 20 MT
5050 60 LED 2 MT 4 MT 8 MT 10 MT 13,5 MT 16 MT 20 MT
5630 60 LED 2 MT 3 MT 6 MT 8 MT 11 MT 13 MT 16 MT
L
N
+
-
+
-
MULTIPLE DC OUTPUT AC INPUT