
It complies with the WEEE regulation.
A
+
Energy
Tel: 0212 244 84 22-23 Pbx
Showroom:
Bereketzade Mah. Şair Ziya Paşa Cad. No:31/A PK. 34421 Karaköy, Beyoğlu / İstanbul
Tel: 0212 879 03 53
Factory:
Beylikdüzü OSB Mh. Mustafa Kurtoğlu Cd. No.23 (Bakırcılar Demirciler Sanayi Sitesi)
Beylikdüzü / İstanbul
Web: www.noas.com.tr
LED T5
BATTEN LUMINARIES
Dear Customer,
This user manual contains the necessary installation information of
the product you have purchased. For your safety and product life,
follow the safety warnings and warranty conditions instructions in the user manual. If you have a
problem with the product, you can contact us via the contact information avaible in the user
manual.
- Do not connect the panel without reading the user manual.
- Cut off the electrical current before assembling the product.
- Do not use the product other than the conditions specified by product protection class..
- Installations of the panel must be carried out by specialists.
- Do not use the product if the power cables are damaged.
- Do not use the product in places where electricity leakage may occur.
- Make sure the product is complete and correctly connected.
- Our products are guaranteed for one-to-one replacement for 2 years.
- In order for the warranty to be valid, the parts must be delivered to the technical services
completely.
- In case the product is defective; Pursuant to Article 11 of the Consumer Protection Law No:6502;
Sanctions are applied to make free repair, to replace the product that cannot be repaired with a new
product.
- Product that are used outside the instructions for use and exposed to user error are not covered by
warranty.
1- Cut off the electrical current before assembling the product.
2- Connect the energy connection of the product in accordance with the connection method specified in the
assembly diagram.
3- You can add the luminaries to each other by attaching the connection apparatus(C) to the open end of the
connection cable(B) specified in the assembly diagram.
4-The ground wire is marked on the connection cable(B). Pay attention to the connection points when
assembling the product.
5- The product is designed to operate at 220-240V and 50-60Hz. Do not operate with a voltage and
frequency other than these values.
6- The protection class (IP) is indicated on the box of the product. It should not be used outside of the ambient
and climatic conditions specified by the protection class.
7- Luminaire is ready to use.
8- You can turn on the electric current.
USER MANUAL
ASSEMBLY DIAGRAM
ASSEMBLY INSTRUCTIONS
EN
SAFETY & WARNINGS
WARRANTY CONDITIONS
Gücünü ve
Potansiyelini Keşfet
220-240V
50-60Hz
30 mm
300 mm
30 mm
600 mm
30 mm
900 mm
30 mm
1200 mm
YL97-0500
YL97-1400 YL97-1800
YL97-0900
A
B
C
A: LED Luminaire
B: Connection Cable
C: Connection Apparatus