Nokia NSE-5 Series Installation instructions

PAMS Technical Documentation
NSE–5 Series Transceivers
Draft 0.4
Disassembly Instructions

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 2
Draft 0.4
[This page intentionally left blank]

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 3
Draft 0.4
1.Remove the Battery
2. Remove Dust Cap
.
Lift off B–Cover 5. Pull out Antenna
note: snap fitting note: snap fitting
3. Remove the Screws (4x)

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 4
Draft 0.4
6. Remove the Screws (2x)
7. Lift off the PCB
8. Remove the Slide Sensor Switch
9. Pull out the Slide until the End Stop

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 5
Draft 0.4
10. Use a pair of Tweezers to push
! DO NOT handle the Slide like this ! ALWAYS handle the slide like this.
The Metal Slide is bent very easily when it is not protected by the phone.
Avoid bending of the Plungers at all times.
the Slide Stopper Spring in the
direction indicated.
11. Simulateously with step 10:
Pull out the Slide past the
End Stop
! note: Pull out straight !
Handling the Slide Assembly:

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 6
Draft 0.4
12. Bend open one side of
the (plastic) Slide Cover
and take out the Metal
Slide
! DO NOT !
Hold the Metal Slide like this.
The Metal Slide is bent very eas-
ily when it is not protected by the
phone. Avoid bending of the
Plungers at all times.
ALWAYS
Handle the Metal Slide like this.
The Metal Slide can be held by the Targa Bow or by one of
the Plungers.
Push the Metal Slide onto
the snap on one side of
the Slide Cover.
Push down the other
side, but do not hit the
middle snap.
Push the Metal Slide onto
the snap on the opposite
side. A click should be
noticed.
Fitting a Metal Slide onto a Slide Cover:

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 7
Draft 0.4
13. Remove the Display Assembly
14. Remove the Keymat Module
15. Remove the Speaker and the Roller Key

PAMS
Technical Documentation
NSE–5
Disassembly Instructions
Page 8
Draft 0.4
16. ! Assemble the whole phone before fitting
the Slide Assembly !
The remaining assembly is done in the reverse
order of the disassembly.
17. Position the right hand Plunger onto
the start of the track and on the
Microphone Connector, as shown
18. Position the left hand Plungers onto the start of the track
and push the Slide Assembly into the phone.
! Push the Slide Assembly straight into the phone to
avoid bending of the Plungers !
Note Torque for screws 0.2Nm