NORTHERN PARROTS 371302 Manual

Bird Carrier Setup Instructions Sh 1 of 2
Connect the front and rear panels to
one side by interlocking the Front
Door Bracket around the Side Panel
Pin. Push in until the latch clicks.
Lay 1 Side Panel flat. Install one
Top/Bottom Panel by sliding it
into the channel on the bottom
of the Side Panel. Push until it
clicks in place. Repeat for the
other panel.
Bracket
Pin
Install the other side panel to
the assembled panels.
Be careful to properly align all panels before
applying force as needed to properly join the
panels together.The panels will be difficult to
separate after snapping in place.
A rubber mallet may be carefully used to snap
the top, bottom, front and rear panels to the
side panels.

Place the perch inside the Carrier. Locate it in
the desired position. Fasten it in place using the
washer and wingnut
Your Bird Carrier is ready for use!
Sh 2 of 2
Handle
Handle Insert
Stand the Carrier upright.
Insert one handle insert in
the bracket on top of each
side panel.
Insert the Handle into the just
inserted Handle Insert.