novocure MyLink User manual

TM
Usage data collection made easier with MyLink™
About MyLink
MyLink enables you to easily upload your Optune®device data to the remote storage server from
the comfort of your home.
WARNING!—All servicing procedures must be performed by qualified and trained personnel. Attempting to open
and service the system may result in an electric shock by touching the inner parts of the equipment. It could also cause
damage to the system.
WARNING!—No modification of this equipment is allowed.
Note: the unit is using a cellular network for its operation. If you are trying to use it in a non-cellular reception
environment, the unit will not work properly.
Mylink is to be used with Optune model TFH9100 only.
MyLink and its indicators next to the Optune device
On/o indicator
Downloading treatment
data indicator
Uploading treatment
data indicator
MyLink Optune device
For questions about MyLink™or services available to you,
contact nCompass™via phone or email.
Translation is available in over 240 languages.
Call us toll free:
1-855-281-9301 (toll free)
Or email us:
[email protected]

1. Plug the cord into the back side of the MyLink
unit and then connect the unit to a wall outlet.
Press the switch to “ ” to power on the unit.
Wait until the indicator stops blinking and
turns steady green.
2. Stop TTFields therapy by pressing the TTFields
button on your Optune device, and unplug
the connection cable from your Optune device.
Connect the MyLink cable located under the
lid of your MyLink unit to your Optune device.
To ensure proper connection, line up the
arrows on the MyLink cord to the arrow on
the Optune device.
3. Make sure that your Optune device is turned on.
The indicator on the top of your MyLink unit
blinks green as MyLink downloads your data.
4. When the indicator stops blinking and turns
steady green and the MyLink beeps, the data has
been downloaded. You can now disconnect the
MyLink cable. Your Optune device will perform
a quick reset. Once the reset is completed, you
can resume your treatment.
5. When the light blinks green, your MyLink
unit is uploading your treatment data directly
to the server. This takes up to 15 minutes.
6. When all 3 lights stop blinking and turn steady
green, the upload is successful. You can now
turn o your MyLink unit and unplug it from
the wall outlet.
MyLink
MyLink
MyLink
MyLink
Optune
device
Optune
device
TM
©2020 Novocure. All rights reserved. nCompass, MyLink, Optune, and
Novocure are trademarks of Novocure. US-OPT-03461v1.0 May 2020
Using your MyLink™