Novus NVQ-4B User manual

USER`S MANUAL VER. 1.0
B/W QUAD PROCESSOR
NVQ-4B
NOVUS SECURITY Sp. z o.o.
359 Pulawska Str., 02-801 Warsaw, Poland
tel: [phone]; fax: [phone]
[email protected]; www.novuscctv.com
© Copyright 2003, NOVUS SECURITY Sp. z o.o.

CCTV – NVQ-4B b/w quad processor user’s manual, v.1.0
© Copyright 2003, Novus Security Sp. z o.o. All rights reserved.
2
FEATURES
Video Input
•Connect up to 4 cameras
Video Output
•Quad and switch video output
Real Time & High Resolution
•Real time refresh rate (EIA:30 frame/sec; CCIR: 25 frame/sec.)
•720(H) x 480(V) (EIA) high resolution
•720(H) x 576 (V) (CCIR)
•256 gray shades
Multi-function
•Independent full screen
•Auto sequential switching
•System auto detection
•Input video gain adjustable
Friendly Design
•User friendly operation
SPECIFICATIONS
•Video input port : 4 cameras
•Video output port : 1 switch & 1 quad output
•Load impedance : 75Ohm
•Power source : DC 12V
•Power consumption : 3W maximum
•Operating environment : 10~80%RH, 0oC~50oC
•Dimension : 240(W) X 45 (H) X 150 (D) mm
•Weight : 1250g
BACK PANEL CONNECTION
Figure 1 - Back panel connection

CCTV – NVQ-4B b/w quad processor user’s manual, v.1.0
© Copyright 2003, Novus Security Sp. z o.o. All rights reserved.
3
Video Input
1. 1,2,3,4: Connect 4 cameras to video input ports
2. G1, G2, G3, G4: Input video gain adjustment
Video Output
1. Switch: Connect this output port to the video input of monitor or TV
2. Quad: Connect this output port to the video input of VCR
Power Jack
Connect to DC12V, 500mA power supply
OPERATION
Power On
After finishing the back panel connection, please plug in DC 12V power supply for power on, then
QUAD light on.
Front Panel Operation
Figure 2 - Front panel keypads
Full Screen
Press one of Full Screen keys such as , the Full Screen Led light on, and the monitor screen will
display whole screen of the corresponding picture.
Quad
Press key, the Quad LED light on, and the quad pictures will be displayed as following camera 1,
2, 3 and 4
1 2
3 4
Figure 3 - Camera location of screen in quad mode

CCTV – NVQ-4B b/w quad processor user’s manual, v.1.0
© Copyright 2003, Novus Security Sp. z o.o. All rights reserved.
4
Switch
1. Press key and the screen will enter auto-switching mode. The switch mode is switched from
QUAD screen to full screen, and dwell time is 3 seconds
2. It will skip the blank channel automatically and only show you the active channels.
System Set Up & Auto Detection
1. CCIR system set up: Press + then power on. Please keep held two buttons more than 1
second for setting up CCIR system internally.
2. EIA system set up: Press + then power on. Please keep held two buttons more than 1 second
for setting up EIA system internally.
3. Auto detection: If you forgot to set up the system, this unit will detect the system from video input 1
automatically during power on.

All rights reserved © NOVUS SECURITY
NOVUS SECURITY Sp. z o.o.