NRG Systems SymphoniePLUS User manual

SymphoniePLUS_Sensor_Connection_Instructions | Rev 2.0 | 23 February 2015 | [email protected] || 1
NRG Sensor Connections to Symphonie PLUS
Introduction
These instructions will assist you in connecting standard NRG sensors to a Symphonie PLUS logger and also
provide the default slope and offset for each sensor type. These default values are preloaded in the
Symphonie PLUS logger (except for iPack voltmeter and RMY Vertical Prop Anemometer) and the Symphonie
Data Retriever (SDR) software. The values are included here as a quick reference only - please see the
Symphonie PLUS manual for logger channel configuration.
Connections

SymphoniePLUS_Sensor_Connection_Instructions | Rev 2.0 | 23 February 2015 | [email protected] || 2
Default Slope and Offsets for Symphonie
Both the Symphonie PLUS logger and SDR software come loaded with default slope and offset values for our
standard sensors. Please note that these settings are specific to Symphonie and Symphonie PLUS and may not
be the same values used for other data loggers. Some sensors are provided with sensor specific values that
may be used in place of these defaults.
Sensor Default Slope and Offsets for use with Symphonie PLUS
Sensor
Slope
Offset
Scaled Units
NRG #40 Anemometer
0.765
0.35
m/s
NRG #200P Wind Direction Vane
0.351
0
degrees
NRG #110S Temperature Sensor with Radiation Shield
0.136
-86.38
C
NRG #BP20 Barometric Pressure Sensor
0.4255
650
mB
Relative Humidity Sensor
0.097
0
%RH
Li-Cor #LI-200SA Pyranometer
1.32
0
W/sqm
Rain Gauge-Tipping Bucket
0.254
0
mm
***iPack Voltmeter SCM***
0.021
0
Volts
RMY Vertical Prop Anemometer
0.0293
-15.00
m/s