NRS Healthcare M11090 User manual

30st
190kg
User Instrucons
M11090 Height Adjustable Toilet Frame with Seat
General Safety Warning
Please ensure these instructions are fully read and
implemented. Failure to do so may result in injury.
Retain these instructions in a safe place for future
reference.
1.0 Intended Purpose
The Toilet Frame with Seat is designed to assist
users when lowering onto and rising from the toilet.
Primarily for use over the toilet using the splash
guard provided but also for use as a commode with
the addition of a potty. The seat lid adds discreet
style and helps to improve cleanliness and hygiene.
2.0 Safety Precautions
Do not exceed the maximum user weight 30st
190kg.
Do not attempt to stand or climb on the product.
Ensure all legs are set at equal height to avoid
rocking.
3.0 Unpacking
Remove packaging and check product carefully. If
any parts appear damaged do not install and
contact your supplier immediately.
4.0 Installation Instructions
Product arrives fully assembled.
To adjust the height:
Remove the ‘e-clip’ and slide the legs to the
desired position.
Align the holes and re-insert the ‘e-clip’.
Repeat for all four legs.
Ensure that all four legs are positioned at the same
height to prevent rocking and instability.
Place the frame over the toilet ensuring that the
internal splash guard is positioned centrally over
the toilet bowl.
To fit M20303 - Commode Pan
Lift the seat and lid to slot the commode pan into
position on the frame, see figure 3.
Maximum User Weight
Figure 1 – M11090
Figure 2 – M20303 Commode Pan
Please visit our website or contact
Customer Services for more details.
Figure 3 – M11090 with Commode
Pan M20303 fitted

Tel. Head Office: 0330 100 0098
Tel. Customer Services: 0345 121 8111
Email: custom[email protected]o.uk
NRS Healthcare is a Leading Supplier of Community Equipment and
Daily Living Aids, to view our full range, visit our website:
www.nrshealthcare.co.uk
UI/M11090/03/18/Iss4
6.0 Cleaning
Clean regularly using a general purpose, neutral
detergent and warm water. Pay particular attention
to the toilet seat hinges and underside of lid.
Please check the suitability of the cleaning products
before use. Do not use abrasive cleaners or cloths
as these could permanently damage the surface
and invalidate any warranty.
To disinfect, wipe with a dilute bleach solution and
rinse thoroughly with fresh water.
Allow the product to dry fully prior to use/storage.
7.0 Maintenance
Check that all fixing clips are inserted correctly and
that there is no excessive movement.
If a floor fixing kit has been fitted, check the fixing
screws are secure.
Inspect the product regularly for signs of wear or
damage, pay particular attention to the condition of
the ferrules.
Any suspected faults or damage should
immediately be reported to the supplier and the
product taken out of use.
8.0 Product Disposal
Product should be thoroughly cleaned prior to
disposal.
Product is manufactured from metal and plastic and
can be disposed of through Local Authority
Household Waste and Recycling Centres or
through local Trade Waste Collectors.
9.0 Product Guarantee
NRS Healthcare guarantee this product for a period
of 12 months, from the date of purchase, against
faulty materials and workmanship. This guarantee
does not cover; abuse, misuse, interference or
tampering with any part of the product.
Any guarantee issued by NRS Healthcare does not
affect your statutory rights.
5.0 Optional Floor Fixing Kit
The floor fixing kit provides a permanent fixing
solution for the Toilet Frame. It helps to prevent the
frame from moving out of position or becoming
unstable during use.
F11572 – Floor Fixing Kit
Available as an accessory from NRS Healthcare.
Call Customer Services 0345 121 8111 or visit
www.nrshealthcare.co.uk
5.1 Fitting Instructions
Adjust the toilet frame to the desired width, see
Section 4.
To fit the legs:
Remove the original leg extensions by
removing the ‘e-clips’ and sliding them out
of the frame.
Insert the four leg extensions and position
at the desired height.
Align the holes and insert the ‘e-clip’.
Ensure that all four legs are secured at the same
height to prevent rocking and instability.
Please note the height cannot be adjusted once the
legs are secured to the floor.
To fix to the floor:
Choose a fixing method which is suitable for the
construction of the floor. A total of 12 screws must
be used, 3 per leg, figure 4.
NRS Healthcare
Sherwood House, Cartwright Way,
Forest Business park, Bardon Hill,
Coalville, Leicestershire, LE67 1UB, UK
Floor Fixing
Leg
Fixing Screws
(Not Included)
‘E-Clip’
Location
Figure 4 –
Installing the
Floor Fixing Kit,
M24308.