Nubert nuGo! ONE User manual

nuGo! ONE Bluetooth Speaker
QUICK START GUIDE
1 Charging .
Please make sure before putting into operation that the battery of the
nuGo! ONE is charged enough. The battery charge level is shown in the
display when the device is in operation. If the battery level is low, it must
be charged as follows:
On the back side there is a plastic cover
with some technical connections behind.
Connect the USB-C jack on the left with the
included power supply unit.
⚠ Notice:
▪ To ensure splash water protection of the
device, the plastic cover must be closed
tightly after it has been recharged.

2 Switching on and off .
By pressing the button the loudspeaker can be activated or turned
off. Press this button for 1 second as minimum for turning off the nuGo!
ONE.
3 Main Menu .
Press and hold the rotary
control for 3 seconds to
switch into menu while the
operating display works
permanently.
Navigate by rotating the
knob. Press the knob to
select a menu point.
Back 1x Menu 3 sec.
By pressing the button Select Rotate
you came back to previous Confirm Press 1x
settings.
4 Choosing source .
Press and hold the rotary
control for 3 seconds to
switch into menu while the
operating display works per-
manently.
Navigate by rotating the
knob. Press the knob to
select a menu point.
Menu 3 sec.
Select Rotate
Confirm Press 1x
Choose with the rotary control your desired source:
▪ AUX

▪ Bluetooth
▪ DAB+ radio
▪ FM/UKW radio
Confirm your choice by pressing the rotary control shortly.
5 Radio mode .
By rotating the rotary control knob, you could set the volume level. To
choose a radio station, press on the rotary control shortly and select…
▪ in FM mode the appropriate frequency or
▪ in DAB mode the radio station you want. (By an initial start-up or a new
installation location, make a station scan firstly.)
To save the currently radio station, press the rotary control once.
▪ In FM mode, the station is marked in orange.
▪ In DAB mode, change to sender list and mark the station you want in
orange.
Press the rotary control for 3 seconds and the radio station will be saved
in the sender list.
If you press the rotary control twice, you will change to the list with the
saved favourite stations.
6 Bluetooth mode .
By rotating the rotary control knob, you could set the volume level.
When pairing with another device firstly, the nuGo! ONE is looking for a
suitable device automatically.
For pairing another device, press the rotary control knob two times suc-
cessionally. The nuGo! ONE will uncouple the first connection and
searches for new devices then.
Tip: For best sound quality, we recommend adjusting the source device
at maximum volume and regulate the volume level with the nuGo! ONE
directly.

Service .
If you may have any questions about your new Nubert product or some
problems with putting into operation, you could gladly contact our Ser-
vice Team. Please hold ready your customer number.
_______________________________________________________________________
Technical changes and misprints reserved. You will find the newest instructions for use and more
information about this product here: http://www.nubert.de/
Our General Terms and Conditions (GTC/AGB) can be found on our website:
www.nubert.de/agb.htm
Nubert electronic GmbH E-Mail: [e-mail]
Nubertstraße 1 Hotline: [phone]
73529 Schwäbisch Gmünd www.nubert.de
Germany © Nubert 05/23