numlighting Dune User manual
Please take the time to read this installation guide before you install
Num Lighting modular light tiles models:
The Num lighting modular light tile must be installed by a professional
electrician in accordance with applicable and appropriate electrical codes.
This guide does not supersede any local and international regulations for
electrical installations.
This product is designed for indoor use and dry locations only.
It is recommended not to place tile in an area of direct sun light. The
material used in this product may show a natural chromatic variation.
The system is designed to be mounted on to a wall only. Do not attempt
to place the Tile system on the ceiling.
The numlighting Tile wall system is patent and design pending.
Warranty – one year limited warranty – numlighting will replace
merchandise only if the nature of defect was a manufacturing defect.
Before installation, maintenance or cleaning, first disconnect the
input power to the system or switch off power.
Dune
Assembly Instructions
Thank you for purchasing num Cuboids Tile.
IP20F
Confirm all components received
Tools needed
x1
x1
x1
x1x2x5x5
x4x1
Not in master
package
Jumper Cable
x1
In master package only
x1x1x1
Do NOT attach tiles onto
a ceiling.
a Plan your composition
One fixture
configuration
could contain
up to 16 tiles
only.
Ensure to have an electric
feeding in the chosen loca-
tion.
b Attach first base
b.1. Attach the base against the wall and mark the central point.
b.2. Set aside the base, drill the marked point, and then insert the
anchor.
There are 4 other optional drilling holes.
Start with the base which will be connected to the electric
feeding.
b.3. Reattach and screw the base while checking alignment.
In case of setting one tile
only, Switch OFF electric
power, and then proceed
to section d.3.
C Attach next base
c.1. Attach the spacers onto the side of the first base, where you
wish to mount the next base.
c.2. Attach the current base to the spacers.
c.3. Mark the central point for drilling.
c.4. Detach the current tile from the spacers and set aside.
c.5. Drill the marked point, and then insert the anchor.
c.6. Reattach the base.
c.7. Screw the base; Recommended to check alignment once
more.
Repeat instructions from section C.1. with all other bases.
Switch OFF electric power
Switch ON electric power only after all jumper cables and
electric feeding cables are connected.
Direct electrical connection
must be assembled by
Professional electrician.
d Connect cables
d.1. Connect electrical jumper cable.
1 2
d.2. Connect the wire-board connector.
d.3. Connect to the electric feeding.
e Attache the Tile
e.1. Connect the controller cable to the back of the tile.
e.2. Connect the controller cable to the base. Tile should lit on.
e.3. Attach the tile to the base.
Done!
Troubleshooting
Light does not turn on?
1. Disconnect the electrical power.
2. Check again all cable and connector connections.
3. Resume electrical power and turn light on.
Technical Suppor t
Phone:
Fax
Email:
Web site:
972-3-7440388
972-3-7440389
info@numlighting.com
www.numlighting.com
Table of contents
