NutriMill SMART JUICER User manual

Owner's Manual
®
SMART JUICER™

Congratulations
On your new Smart Juicer™portable slow juicer.
Please read through this entire manual before first
use, and keep for future reference. So that you may
enjoy your new NutriMill®product for years to come.

1. The proper input voltage is 5V, please confirm before charging and
always charge properly.
2. If any damage is found, please stop using the product and contact
our customer service department.
3. Before switching on the power supply, please ensure that all parts are
installed properly and, fully tightened to avoid leakage of juice, and
other abnormalities during product operation.
4. The product is equipped with intelligent protection components. In
the process of using the product, the automatic protection will stop
working due to excessive power. If you need to continue using the
product, please wait for 10 minutes before restarting
5. If there is overload or blockage, the juicer will automatically stop. It is
recommended to remove food from the feeding tube after reversing
before continuing.
6. Remove seeds, hard seeds, thick skins or hard shells before juicing.
7. Do not juice hard and fibrous ingredients, such as ice cubes, coconut,
sugar cane, etc. Such ingredients may cause blockage or damage.
8. Do not force ingredients, gentle downward pressure is best.
9. Keep away from children
10. Do insert fingers or anything other than the included pusher into the
feeding tube.
11. This item is NOT dishwasher or microwave safe; hand wash only. Do
NOT submerse motor.
12. Discoloring may occur in some components after juicing certain
foods, this is normal and does not affect quality of the juice or juicer.
13. Do NOT use abrasive cleaners or corrosive liquids to clean product.
14. This product is intended for household use only.
IMPORTANT SAFEGUARDS

Parts Included
Wash all parts that come into contact with food before first use.
Battery: 5v 60w
Charge time 20-30 Minutes
Working time 10 Minutes.
The product will not function unless
properly assembled.
Press switch to ON position to begin
juicing.
Press REV to stop juicing or hold
down to reverse motor in case of jam.
ON
OFF
REV

Assembly
1. Confirm the bottom of
silicone plug is installed before
installing the juicer container.
If not, the juice will flow out or
the juice rate will be reduced.
2. Align the convex groove on the
juicing cup with the groove on
the base.
3. Install the filter onto plastic
guides.
4. Align the screw with the center
of filter bracket, and insert it.
5. Align the lid with the juice
cup, and rotate clockwise until
locking in place.
6. Place containers under each
outlet.
7. Only insert the included pusher
into the feeding tube.

Juicing
1. Prepare Ingredients to be juiced.
• Wash the ingredients and cut into proper sizes.
• Cut spinach into small pieces before squeezing.
• Remove hard seeds, rinds, or other hard outer shells.
2. Press the ON button.
3. Place ingredients into feeding tube, and push down with the pusher
as needed.
4. Press the REV once food is juiced and juice flow has stopped.
5. Adjust the quantity of juice with
handy pull-out on the juice outlet.
6. It is recommended to drink the freshly squeezed juice as soon as
possible. If it is exposed to the air for a long time, the taste and
nutritional value may be affected.
7. Disassemble and hand wash immediately after use.
8. When the working duration exceeds 9 minutes and 30 seconds,
the product starts to emit an alarm sound. Once the alarm has
sounded turn off the juicer and allow to cool for 5 to 10 minuets
before resuming use. If the user does not stop the operation in time
in the alarm zone, the product will automatically stop working within
30 seconds after the alarm sounds. At this time, directly turning on
the product switch is invalid. You need to rest for five to ten minutes
to unscrew the cup lid counterclockwise, and then turn it clockwise
again. After hearing a chime, the device is activated and can be used
normally again.

Juicing Tips
1. Use fresh fruits and vegetables. Suitable ingredients include: apples,
pears, grapes, melons (watermelon, cantaloupe, etc.), celery sticks,
beetroot, carrots, spinach, wheat grass etc.
2. Thick skins such as cantaloupe and beetroot need to be cut off. The
seeds of citrus fruit will make the juice bitter, it is recommended to
remove.
3. The amount and taste of the juice depends on the freshness and type
of selected fruits.
4. Freshly squeezed apple juice will quickly turn brown, which is normal
because of oxidation.
5. Leaves and stalks (such as celery, lettuce) can be juiced in the juicer.
6. Fruity and soft ingredients, such as: strawberries, tomatoes,
pineapples, kiwis, etc., contain less juice. It is recommended to use
harder and juicier ingredients.
7. Softer ingredients should be juiced first, then squeeze the harder
ingredients.
8. Foods with more fiber, such as sugar cane are not suitable for juice
extraction with this product.
9. Starch-containing ingredients such as bananas, papayas, avocados,
figs, and mangoes are not suitable for juicing with this juicer.

Visit NUTRIMILL.COM to nd recipes,
accessories, and so much more!
Contact us at:
1-800-692-6724 | [email protected]
with any questions or concerns you may
have with your product.
4196 South 950 East
St. George, Utah 84790
®