NYSW FIFTH AVENUE SERIES User manual

New York Standard Watch Company . www.newyorkstandardwatch.com
NYSW Quick Setup Guide IM code: M55A
Step 1: First Time Use- FOLLOW INSTRUCTIONS CAREFULLY!
Please place your watch near a window for no less than 24 hours and a maximum of 48 hours in order to receive the radio signal. For
the best possible reception please place your watch on a flat surface in a face down position.
There are other functions that are provided by the manufacturer for your Atomic Watch. You may go through them in the extended in-
struction manual enclosed but please go through the “Quick Setup Guide” initially step by step prior to reading the extended manual .
Step 2: Check the Second-hand position
When you take out the watch out of the packaging, please press S1 (upper) button once and see if the second hand’s position
will point exactly at 6 O’clock or 12 O’clock.
During shipping the second hand may shift, therefore if the second hand does not point to either 6 O’clock or 12 O’clock, then you
need to re-calibrate the second hand to the correct position.
1. Press-release S1 once while the watch is running regularly
2. If the watch received signal during the past 24 hours, the second-hand will pause at 12 o’clock
3. If the watch didn’t receive signal during the past 24 hours, the second-hand will pause at 6 o’clock. Just leave the watch near
a window for over night and check the second-hand position again.
Don’t push any button after the second-hand has stopped. Wait until it moves again.
. If the second-hand does not pause at either the 6 or the 12 o’clock position, please read the Procedure to calibrate the shifted
second-hand section in TROUBLESHOOTING section of the Extended Instruction Guide.

New York Standard Watch Company . www.newyorkstandardwatch.com
NYSW Quick Setup Guide IM code: M55A
Step 3: Time Zone Setting (for USAusers ONLY! )
Check USATime Zone Setting
1. Press and release S3 (lower )button once while the watch is running normally.
2. LED light indicates the USATime Zone setting as below:
RED (Stable light) = Pacific (P)
Green (Stable light) = Mountain (M)
RED (Flashing light) = Central (C)
Green (Flashing light) = Eastern (E)
RED+GREEN light flashing at the same time = not being set to a USATime Zone
3. Press and release S3 to Exit
USATime Zone Setting
1. Press-release S3 once while the watch is running normally
2. LED lights up underneath from the watch dial (watch face) to show the current USATime Zone setting of the watch
3. Press-release S1 or S2 to set the watch to a new USATime Zone according to the following table:
RED (Stable light) = Pacific (P)
Green (Stable light) = Mountain (M)
RED (Flashing light) = Central (C)
Green (Flashing light) = Eastern (E)
If RED+GREEN light flashing at the same time indicates that the watch is currently not set to any USA time zone. This happens
when you travel abroad and your watch has been set to an overseas time zone outside USA.
4. To confirm a new USATime Zone setting or Exit, press-release S3 once or the watch will Exit by itself after 30 seconds
5. The watch will run fast and adjust itself to the new time automatically after you have set it to a new USATime Zone.
**It may take up to minutes to 40 minutes for the watch to reset. If the second hand doesn’t go fast spinning or can’t stop from fast
spinning, please call our Technical Support Toll Free number 1-800-399-1629.
CAUTION!
DO NOT push any of the 3 buttons while the second hand is stopped or is spinning fast. Wait until the second
hand moves regularly.