OAK STREET 0621 User manual

Assembly Instructions
Black Stamped Steel ‘T’ Table Bases
1. Flip your tube/spider
so the spider is on the
ground and the bottom
of the tube is facing up.
2. Screw out the short
bolt in the bottom
of the tube/spider.
4. Using the socket set
or crescent wrench,
screw in the short
bolt with lock washer
and flat washer into
the tube
3. Place the ‘t’ foot on
the tube.
5. Locate the leveling glides and
screw into the welded end tabs
of the ‘t’ foot.
6. Your table base
is now ready to
be mounted to
the table.
7. Place the table
base onto the
bottom side
of the table.
Crescent wrench
or socket set
Drill driver or
screwdriver Tape measure
What you will need for assembly: What’s in the box:
(8) 3/4” #10 screws
per base

9. Use the 8 perimeter
holes on the spider
(circled in yellow) to
fasten the base to
the table top.
10. Using the screwdriver or
drill driver and (8) 3/4”
#10 screws, fasten the
base to the table top.
12. Assembly is complete. Enjoy
your Oak Street Manufacturing
black stamped steel table base!
255 Welter Drive
Monticello, IA 52310
P: 877.465.4344
F: 877.465.4042
www.oakstreetmfg.com
Thank you for your business!Thank you for your business!
8. Measure from the table
end. The base can either
be 12” from the edge of
spider to table edge, or
12” on center from table
edge - depending on the
need.
Then measure from
the spider’s edge to
the sides of the table to
ensure it’s centered.
11. Repeat steps 1-9 with the
other ‘t’ base on the opposite
end of the table.