OAK STREET JUBILEE User manual

Hardware Included:
• A - Qty: 16 3/8”-16 bolts + nuts
• B - Qty: 4 Base levelers + lock nuts (black)
• C - Qty: 4 5/8” wood screws
A
A
A
A
B
C
Tools Needed (not included):
• Wrenches and/or socket set
• Phillips screwdriver
Parts Included:
• D - Qty: 1 Top frame
• E - Qty: 2 Legs
D
E
Step 1: On a clean, flat surface
(such as a table topped with
cardboard, place the top frame
(D) on it’s side.
NOTE: There are bright green
stickers placed on the side of
the top frame that you need to
attach the legs to. The other
side will not allow a flush fit
and cause assembly issues.
Step 2: Place one of the legs
on it’s side and with the leg
supports facing toward the top
frame.
Step 3: The top frame has mounting plates on
both ends with matching hole patterns to the
frame legs. Attach the leg to the top frame using
8 of the 3/8”-16 bolts & nuts (A). 4 on each end.
Bolts go through the top frame then the legs -
pointing towards the bottom.
Step 4: Using a socket set and wrench, tighten all 8
bolts. 4 on each end.
Repeat Steps 2-4 on the opposite end of the frame.
ASSEMBLY INSTRUCTIONS
JUBILEE TABLE FRAME

Step 5: On the bottom of the table legs, There are 2 holes to insert the base levelers (B).
From the bottom side, insert the levelers through the hole towards the top frame.
Use the black lock nuts on the top side to secure the base levelers in place.
Step 6: Flip the frame with legs and glides
attached to the top side up position.
**2 person lift**
NOTE: On the COMPCOR table tops, there are 2
exterior-grade plywood backers. The center plates
on the top frame will be screwed to the table tops
backers using the 5/8” wood screws (C).
Step 7: Place the COMPCOR table
top onto the frame. Ensure it is
evenly spaced around all sides.
**2 person lift**
Step 8: From the underside
of the table, screw through the
frame’s center plates into the
table top’s backers using the
5/8” wood screws (C).
2 per plate/backer = 4 total.
Congratulations!
Your Jubilee top is assembled.