Occasions Airflowz Series User manual

Safety Information
Please read and understand this entire manual before attempting to assemble, operate or
install the product.
- This item is not a toy and should be used for decorative purposes only.
- For indoors and outdoors use.
CAUTION:
Do not attempt to inflate your inflatable during unusually strong winds. If
it becomes too windy for safe operation, simply allow your inflatable to deflate and wait for better
conditions before re-inflating.
CAUTION:
Protect the electric fan and power cord from direct exposure to water. This precaution will reduce
the risk of electrical shock. When the temperature is below 14°F (-10°C), the motor may tempo-
rarily stop running. The motor will begin functioning again in higher temperatures.
Warning: Read And Understand All Instructions
- Failure to follow all instructions listed below, may result in electric shock, fire and /or serious
personal injury.
WARNING : ELECTRICAL PRODUCT
- Keep away from children. Not recommended for children under 3 years of age. As with all
electrical products, precautions should be observed during handling and use to reduce the risk
of electric shock. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
DANGER
- To prevent electric shock, do not immerse in water; wipe clean with damp cloth. Immersing this
product can result in an electric shock.
IMPORTANT NOTE:
Periodically examine this product for damage to the cord, housing or other parts that may result
in the risk of fire, electric shock or injury. If the product is damaged, do not use it.
Important Safety
Instructions
Read And Follow All
Safety Instruction
When using electrical products, basic
precautions should always be followed,
including the following:
- This is an electrical product – not a toy! To avoid risk
of fire, burns, personal injury, and electric shock, it
should not be played with or placed where small
children can reach it.
- Do not use seasonal products outdoors unless marked
suitable for indoor and outdoor use. When products
are used in outdoor applications, connect the product
to a Ground Fault Circuit Interrupting (GFCI) outlet. If
one is not provided, contact a qualified electrician for
proper installation.
- This seasonal use product is not intended for
permanent installation or use.
- Do not mount or place near gas or electric heaters,
fireplaces, candles, or other similar sources of heat.
- Do not secure product wiring with staples or nails or
place on sharp hooks or nails.
- Do not let lamps rest on the supply cord or on any
wire.
- Unplug the product when leaving the house, when
retiring for the night, or if left unattended.
- Do not use this product for other than its intended
purpose.
- Do not hang ornaments or other objects from cord,
wire, or light string.
- Do not close doors or windows on the product, or
extension cords, as this may damage the wire
insulation.
- Do not cover the product with a cloth, paper, or any
material not part of the product when in use.
- Do not place the product against carpeting, furniture,
or any other fabric when in use.
1 2
- This product has a polarized plug (one blade is wider
than the other) as a feature to reduce the risk of
electric shock. This plug will fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet,
reverse the plug. If the plug still does not fit, contact a
qualified electrician. Do not use an extension cord
unless the plug can be fully inserted. Do not alter or
replace the plug.
- Before using and reusing, inspect the product
carefully. Discard any products that have cut,
damaged or frayed wire insulation cords, cracks, lamp
holders or enclosures, lose connections, or exposed
copper wire.
- When storing the product, carefully remove the
product from wherever it is placed, including trees,
branches, or bushes, to avoid any undue strain or
stress on the product conductors, connections and
wires.
- When not in use, store neatly in a cool dry location
protected from sunlight.
- Read and follow all instructions that are on the product
or provided with the product.
Light Up
Inflatable
Instructions
WHISPER SYSTEM

Package Contents
Part Description Quantity
A Inflatable Unit with 1 PIECE
UL Listed adapter
(Input 120V, AC 50/60Hz,
Output 12V, DC 1.5A)
B Tether ropes 4 PIECES
C Tether stakes 4 PIECES
D Stakes 2 PIECES
Caution:
1. For even better night time illumination, you may choose to place an outdoor approved spotlight
in front of your inflatable. (Outdoor approved spotlight not provided). Do not place the bulb too
close to the inflatable as it may melt or damage the plastic.
2. Do not place any foreign objects inside your inflatable.
3. Do not block air intake area of your inflatable; it will increase the inflation time.
4. During inclement weather conditions such as heavy rain, snow and windstorms, store the
product indoors.
5. Operation of your inflatable during extreme weather conditions is not recommended.
6. Do not store the inflatable when it is wet.
Important Safety Instructions: Power Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical products, basic precautions should always be practiced including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2. Read and follow all instructions that are on the product or provided with the product.
3. Do not use an extension cord.
4. Reference the National Electrical Code, ANSI/NFPA 70, specifically for the installation of wiring and
clearances from power and lighting conductors.
5. Installation work and electrical wiring must be done by qualified person(s) in accor dance with all
applicable codes and standards, including fire-rated construction.
6. Do not install or use within 10 feet of a pool.
7. Do not use in a bathroom.
8. WARNING: Risk of Electric Shock. When used outdoors, install only to a covered Class A GFCI protected
receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided,
contact a qualified electrician for proper installation. Ensure that the power unit and cord do not interfere
with completely closing the receptacle cover.
9. WARNING: Risk of Fire. Installation involves special wiring methods to run wiring
through a building structure. Consult a qualified electrician.
10. WARNING: Risk of Electric Shock. Mount the unit at a height greater than 1 foot from the ground surface.
11. Do not to use with receptacles that are weatherproof only when the receptacle is covered (attachment
plug cap not inserted and receptacle cover closed).
SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for
power units.
3 4
12
3
weight-bag
5
Assembly Introduction
1. Lay out deflated inflatable on a clear and flat
area with fan at the back facing up. Make
sure the air intake is clear of fabric or other
obstructions.
2. Ensure zipper on inflatable is fully closed.
3. Plug the adapter into a power unit. Inflatable
will start to inflate.
4. For outdoor use, tie tether ropes to the
stakes, clip the nylon loops on the side of
inflatable, then insert stakes to the ground
making sure tethers are taut.
5. Adjust the sealed weight-bag to position
your inflatable.
6. To deflate, unplug adapter and the fan will
stop blowing.
7. Unzip the zipper for faster deflation.
Fan
facing
up
SAVE THESE INSTRUCTIONS
Installation
PREPARING FOR INSTALLATION
1. Remove contents from packaging
2. Remove all plastic fasteners and tags. These are part of the packaging and should be discarded.
3. Before beginning assembly of product, make sure all parts in the content list are present. If any
part is missing or damaged, do not attempt to assemble the product.
D
B
A
C
4

WARNING:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
- Warning: Changes or modifications to this unit not expressly approved by the party respon-
sible for compliance could void the user’s authority to operate the equipment.
- NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Care And Maintenance
1. Before using and reusing, inspect the product carefully. Discard any product that has cut,
damaged or frayed wire insulation cords, cracked lamp holders or enclosures, loose connec-
tions, or exposed copper wire.
2. Wipe the unit with a damp cloth and allow the unit to dry before storing.
3. When storing the product, carefully remove it from wherever it is placed, including trees,
branches, or bushes to avoid any undue stain or stress on the product conductors,
connections and wires.
4. When not in use, store neatly in a cool, dry location protected from sunlight.
Troubleshooting
Problem: The unit is not inflating.
- The power source is disabled or the cord may be unplugged. Check all power cables to make
sure that they are properly connected to a power source. Ensure that the power outlet has
power.
- Debris may be lodged in the motor. Unplug fan unit and remove any foreign objects or debris
from the motor.
NOTE: Periodically, the inflatable air-intake area may become clogged with grass, leaves or
other debris. For best results, it is recommended to check this air-intake area and clean as
necessary.
- Occasionally, the hanging fabric of a partially inflated inflatable can become attached to the
motor’s air- intake area. Ensure that fabric is not hanging near the motor during inflation.
- The zippers that seal the inflatable may not be completely closed. Make sure the zipper is zipped
closed.
- The temperature may be below 14ºF (-10ºC). Remove the unit from extreme temperatures until
weather conditions improve.
- The connection between the inflatable and fan may not be securely attached.
Problem: The unit is torn.
- You may hand sew rips with any type of thread or use clear packing tape to cover the tear.
Problem: There is delay after plugging in the adaptor.
- This is a protective feature built in to these adapters to protect your electrical circuit and the
product. 2-3 seconds start up delay is normal.
Questions or Problems?
Visit our website www.toysinquiry.com or call our customer service department at
1-800-434-6178 for expedited assistance.
65

FAQ
1. Can I continually run the inflatable?
Yes, you can run the inflatable during the day and at night. It is recommended you turn off the
inflatable when leaving the immediate area and when retiring for the evening. Otherwise, the
inflatable is designed to run continually.
2. Can I leave the inflatable up in extreme weather conditions or freezing temperatures?
It is recommended you take appropriate precautions to protect the unit. The inflatable will
operate at temperatures below freezing, but it is not recommended to operate the inflatable if
temperature drops below 14°F (-10 C˚).
3. What if it is raining or snowing? Will this affect the inflatable?
Operation of the inflatable during light weather conditions such as a gentle rain or snowfall is
intended. However, operation of the inflatable during extreme weather conditions is not
recommended, as your item may become damaged or inundated with moisture. Do not store
the inflatable when it is wet.
4. What if water has soaked my unit while unplugged?
Move the unit to a dry location and plug in the unit. The fan will dry the inflatable.
5. The inflatable has been deflated and it is covered with snow. Can I simply re-inflate it?
If the inflatable is covered in a light dusting of snow, simple re-inflation should not harm the
unit. However, if the deflated unit has been subjected to a large amount of snow and or ice, do
NOT attempt to re-inflate. Rather, carefully remove the item from the extreme condition (i.e.
bring it indoors) and allow the unit to thaw before re-inflating. This helps prevent cracks and or
tears in the material.
6. When I unplug the inflatable, it deflates. Why is this?
The inflatable will not stay inflated unless it is plugged in and the fan is blowing air.
7. How can I clean the inflatable?
Wipes clean with a damp cloth and allow to dry before storing away.
8. What is the best way to store the inflatable?
Store in a bag, box or other storage container and keep in a cool, dry location.
DC - 0.95 - 1 E 2014
7
DO NOT RETURN TO STORE
THIS PRODUCT CANNOT BE RETURNED
FOR A REFUND AFTER
IT HAS BEEN UNPACKED AND USED.
FOR QUESTIONS OR PROBLEMS WITH THIS PRODUCT
PLEASE VISIT BELOW CUSTOMER SERVICE WEBSITE
FOR EXPEDITED ASSISTANCE
www.toysinquiry.com
CONTENTS AND SPECIFICATION MAY VARY FROM THOSE ILLUSTRATED.
125, QI WEN ROAD, HAI SHU, NINGBO, CHINA
ALL RIGHTS RESERVED
MADE IN CHINA
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE.