Ofs The Edge Canopy User manual

The Edge Canopy assembly instructions

2ofs.com imagine a place® 800.521.5381 Assembly instructions
The Edge Canopy assembly instructions
1. Drill
Tools required
Canopy assembly
Support rail Idea Lounger
#8 x 2"
Pan Head
Composite
Deck Screw
#8 x 1-1/2"
Pan Head Screw
Slat

3ofs.com imagine a place® 800.521.5381 Assembly instructions
The Edge Canopy assembly instructions
Assemble canopy
1. Begin by placing the three “L” shape support rails in a line as shown.
2. Making sure the pre-drilled holes are aligned, attach seven slats to the ceiling surface of the
support rails using the supplied 2" deck screws as shown.
Attach canopy to lounger
1. Locate the seven pre-drills on the side of the lounger end panel.
2. Place the canopy up against the lounger and visually check to make sure all seven mounting
holes line up with one another. Once the lounger and canopy are aligned, attach the canopy to
the lounger using the supplied 1-1/2" wood screws.

4ofs.com imagine a place® 800.521.5381 Assembly instructions
The Edge Canopy assembly instructions
Attach remaining slats
1. Making sure the pre-drilled holes are aligned, attach all remaining slats to the vertical surface of
the support rails using the supplied 2" deck screws as show.
2. When the assembled unit is placed in its final position, verify that all fasteners are tight and unit
is level.