Oki SHD4-755AI-VD User manual

SHD4-755AI-VD
SSD4-742AI-VD
OKIUSA Rev.03/06
④.If the video product has been dropped or the cabinet
has been damaged.
⑤.When the video product exhibits a distinct change in
performance.
1. Lead (Pb) Free RoHS Compliance (SHD4-755AI-VD
model only).
2. Equipped with SONY HQ1 DSP (SHD4-755AI-VD model
only).
3. Long life and high reliability are achieved by the use of a
CCD image device. This makes the camera 100% solid
state.An image tube is no longer needed.
4. Built-in Aspherical lens
5. No focus shift in the nighttime.
6. Relatively no interference from magnetic or electrostatic
field.
7. Ease of use in any application is achieved through the
smallshape.
8. Lower power consumption.
1. Never point the camera toward the sun
Do not expose the lens directly to the sun or to strong light
as this may damage the pick-up device.
2. Handle this camera with care
Avoid any shock or bumping of the camera. Improper
handling could damage the camera.
3. Requires a proper operating environment
This camera is designed for indoor use. The allowable
temperature range for operation of this camera is between
-10 ℃~50 ℃and the allowable humidity is 85%RH
maximum.
4. Clean the front face to the pick-up device
It is recommended that the pick-up device surface be
cleaned before lens installation or whenever the lens is
changed. Cleaning should be done by using a chamois、a
very fine soft cloth、lens tissue or cotton tipped applicator
and ethanol to carefully remove any fingerprint or dust.
5. Check the power source voltage
The power source voltage should be within the specified
range. (Camera must meet the specifications).
6. Objects and liquid entry
Never push objects of any kind into this camera as this
may touch dangerous voltage points of short out parts that
could result in a fire or electric shock. Never spill any kind
of liquid on the video product.
7. Servicing
Do not attempt to service this video product by yourself as
opening or removing covers may expose you to dangerous
voltage or other hazards. Refer all service to qualified
servicing personnel.
8. Damage requiring service
Unplug this video product from the wall outlet and refer
service to qualified servicing personnel under the following
conditions:
①.When the power supply cord or plug is damaged.
②.If liquid has been spilled, or objects have fallen into the
video product.
1/3” Color Varifocal Vandal Proof Dome Camera ③.If the video product has been exposed to rain or water.
Optional: MB-HVANDAL
SPECIFICATIONS
Wall Mount Bracket
Model SHD4-755AI-VD SSD4-742AI-VD
Image Sensor 1/3” SONY Super HAD CCD
DSP SONY HQ1 SONY
Number of Total Pixels NTSC: 811(H)×508(V)
PAL: 795(H)×596(V) NTSC: 537(H)×505(V) PAL: 537(H)×597(V)
Video Output 1.0Vp-p Composite/75 Ohm
Resolution 550TVL 420TVL
Minimum Illumination 0.25 Lux @ F1.2 0.15 Lux @ F1.2
Signal to Noise Ratio More than 50dB
(AGC OFF) More than 48dB (AGC OFF)
Synchronizing System Internal
Electronic Shutter
Speed Mode
Back Light
Compensation
Auto Gain Control
Flickerless
ON/OFF
DC Level The VR for adjusting the IRIS level of
Auto Iris Lens
White Balance AWB 2500°K ~ 9200°K
Lead Free YES N/A
Lens/Angle of View
(Horizontal)
Standard : 3.8mm-9.5mm/F1.2 Aspherical
AutoIrisLens/74.2°~30.0°
Optional : 2.5mm-6.0mm/F1.3 Aspherical
Auto Iris Lens /108.2°~47.6°
9.0mm-22.0mm/F2.0AutoIrisLens
/29.2°~13.0°
Power Supply
Standard:
12V DC / 170mA ;
Optional:
12V DC / 24V AC
Standard:
12V DC/150mA ;
Optional:
12V DC/ 24V AC
Power Consumption 2.0W 1.8W
Operation Temperature -10°C ~+50°C
Storage Temperature -20°C ~ +60°C
Storage Humidity Maximum 85%RH
Weight 12V DC: 300g ; 12V DC/24V AC:370g
FEATURES
CAUTIONS
Dimensions 118(Ø) × 88(H) mm
DIMENSION

OKIUSA 03/06
①. FAR/NEAR
NOMENCLATURES AND FUNCTIONS
① ②③④
②. WIDE/TELE
③. DC LEVEL
The VR for adjusting the IRIS level of Auto Iris Lens.
④. SWITCHES
(1). AES/OFF
AES : Automatic Electronic Shutter. The range of
shutter speed from 1/60sec. (1/50sec.) to 1/100,000
sec.. This mode is employed for using a manual iris
lens.
OFF :AES OFF. The shutter speed is 1/60sec.
(1/50sec.).
When an auto iris lens is applied, AES should
be off.
(2). BLC/OFF
BLC : Backlight Compensation. When the object is
dark by strong light (sunlight etc….) as (Fig.2-1),
please turn on BLC.
OFF : BLC OFF.
(3). AGC/OFF
AGC : Automatic Gain Control. The level of gain
Varies from 0 to 26dB.
OFF :AGC OFF. The level of gain is fixed at 0dB.
(4). FL/NOM
FL : Flickerless. In FL mode, the shutter speed is
1/100sec. (NTSC system) / 1/120sec. (PAL ).
If choose FL mode, [AES] switch should be off.
NOM : Normal position.