Okina ECO Series Quick start guide

EIR42-42VF_rev08072008
EIR42-42VF
EIR42-42VFP
Operational Manual
IR Day & Night Weatherproof Color Camera
1/3” Sony Super HAD CCD
420 TV Lines
42 IR LED
3.5mm~8.0mm Vari-Focal Lens
0.5 Lux @ F1.2 (0 Lux @ IR “on”)
IR Distance 80~100ft / 24~30m
Weatherproof IP65 Rating
330~410mA IR LED “on” / 90~110mA IR LED “off”
12V DC
1. Sun shield cover can be moved forward or
backward based on needs.
2. Install the camera to the bracket by using the
screws.
3. Install the bracket to the wall or any place using
the screws.
4. Connect the camera to the monitor and power
equipment.
5. Adjust the lens.
6. Place the lens adjustor cover on the lens
adjustor and screw it onto the camera with the
screw provided. You MUST follow this step if
you are using the camera outdoors.
FCC NOTICE:
This equipment has been tested and found to comply with
the limits for a class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates radio frequency, and if not
installed and used in accordance with the instruction
manual, may cause harmful interference.
Model EIR42-42VF EIR42-42VFP
TV System NTSC PAL
Image Sensor 1/3” Sony Super HAD CCD
DSP Sony
Total Pixels 510(H) × 492(V) 500(H) × 582(V)
Video Output 1 Vp-p 75 Ω
Resolution 420 TV Lines
Minimum
Illumination 0.5 Lux @ F1.2 (0 Lux @ IR “on”)
S/N Ratio More than 48dB
Electronic
Shutter Speed 1/60~1/100,000sec 1/50~1/100,000sec
Synchronization Internal
Gamma Control 0.45
Gain Control Auto
White Balance Auto
Back Light
Compensation Auto
IR LED 42 IR LED
IR Wavelength 850nm
IR LED Life 10,000 Hours
IR Working
Distance 80~100ft / 24~30m
Lens 3.5mm~8.0mm Vari-Focal Lens
IP Rating Weatherproof IP65
Power Supply 12V DC
Power
Consumption 330~410mA IR LED “on” 90~110mA IR LED “off”
Operation
Temperature 14oF ~ 104oF / -10oC ~ +40oC
Dimension 3.54”(W) x 3.78”(H) x 6.30”(L)
90mm(W) x 96mm(H) x 159.9mm(L)
Weight 950g
* Specifications are subject to change without notice
FEATURES
SPECIFICATIONS
Please read the Operational Manual
before attemptin
g
to use this product.
INSTALLATION INSTRUCTIONS
NOTE: Sun shield cover’s maximum forward
movement can only reach the cease point.

EIR42-42VF_rev08072008
One (1) EIR42-42VF or EIR42-42VFP Camera
(with power/video cable) with Sun Shield
Waterproof Cover
One (1) Waterproof Lens Adjustor Cover
One (1) Screw for Waterproof Lens Adjustor Cover
One (1) Operational Manual
1. Never point the camera toward the sun
Do not expose the lens directly to the sun or to strong light
as this may damage the pick-up device.
2. Handle this camera with care
Avoid any shock or bumping of the camera. Improper
handling could damage the camera.
3. Requires a proper operating environment
This camera is designed for outdoor or indoor use. The
allowable temperature range for operation of this camera
is between 14F~ 104F / -10C ~ 40C and the allowable
humidity is 85%RH maximum.
4. Clean the front face to the pick-up device
It is recommended that the pick-up device surface be
cleaned before lens installation or whenever the lens is
changed. Cleaning should be done by using a chamois, a
very fine soft cloth, lens tissue, or cotton tipped applicator
and ethanol to carefully remove any fingerprint or dust.
5. Check the power source voltage
The power source voltage should be within the specified
range. (Camera must meet the specifications). Camera
must be connected to a surge protector at all times.
6. Objects and liquid entry
Never push objects of any kind into this camera as this
may touch dangerous voltage points of short out parts
that could result in a fire or electric shock. Never spill any
kind of liquid on the video product.
7. Servicing
Do not attempt to service this video product by yourself
as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all service to
qualified servicing personnel.
8. Damage requiring service
Unplug this video product from the wall outlet and refer
service to qualified servicing personnel under the
following conditions:
a. When the power supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen
into the video product.
c. If the video product has been dropped or the
cabinet has been damaged.
d. When the video product exhibits a distinct change
in performance.
ADDITIONAL CAUTIONS:
Be careful not to shake the camera.
Please avoid places where direct sunlight may
shine on the camera.
Please avoid places where there are frequent
vibrations or shocks.
Please avoid places where the temperature
exceeds 14F / 40oC or temperatures lower
than 104F / -10oC.
Please avoid storing and operating the
camera in water.
Please avoid water spills on the video
connectors and the DC jack connectors.
Make sure the power input is correct.
Screw the lens adjustor cover onto the
camera if you are using it outdoors.
This product is covered under warranty for one year from
the date of purchase. The warranty will automatically be
voided if any of the following occurs:
1.
Camera sticker is removed
If the camera sticker is removed, we will not be able to
confirm any information regarding when and where the
product was purchased. We have no other way to verify
the purchase record without the serial number on the
camera sticker; therefore, it should not be removed.
2.
Camera is modified in any way
If the camera is scratched, damaged, or modified in a
manner not described in this manual, the warranty will
be voided immediately. It is the customer’s
responsibility to keep the camera in good condition.
3.
Video or power cable is cut
The video cable and the power cable should not be
tampered with. Cutting or modifying of the cables will
result in termination of the warranty.
DIMENSIONS
(
Unit: mm
)
CAUTIONS
WARRANTY
PACKAGE CONTENTS