olympia electronics RF-58 User manual

930058000_09_004
Page 1 from 3
RF-58
PRESENCE INDICATION LED (red and green LED)
DESCRIPTION
The RF-58 is a device that is used to indicate
the presence of a customer in a hotel or rented
room. The device operates in cooperation with
the RF-57 and RF-43 or RF-85, that are
products from our company. With the connection
shown on figure 4, when the room is empty then
the RF-58 emits a green color whereas when
there is someone in the room the unit emits a
red color.
INSTALLATION
The installation of the device can be done on an
interior wall by recess mounting it in an electrical
wall switch box or it can be mounted on a false
ceiling. (Figure1 and 2). The electrical box must
have at least a 4cm depth and screw holes from
mounting the unit.
Figure3 shows the connection of the RF-58 with
the RF-57 and the RF-43/RF-85. In the same
diagram we can also see the suggested cable
cross sections.
You can order the unit with a gold decorative
ring (Α-82/G) or with a silver decorative ring
(Α-82/SL).
Figur e 2
Figur e 3
Install the ring on the electrical box
and fasten it with the supplied screws
After making the connection (figure 4),
place the unit on the electrical box
and lock in into place by rotating towards
the right
TECHNICAL CHARACTERISTICS
Operation voltage
Degrees of cover protection
Consumption (Max.)
Produced in accordance with
Operation temperature
Humidity
Construction material
Dimensions
Weight
Guarantee
220-240V AC/50-60Hz
2 years
Up to 95% relative humidity
0 to 40 °C
IP20
7 VA
Bayblend FR-3010 - polycarbonate (opaque)
78 (diameter) x 50 (height)mm
60 gr
EN 60598-1, ΕΝ 60598-2-1
RF-58/T
Dimensions in σε mm
Figur e 1
78 50
Thank you for your trust in our products.
Olympia Electronics - European manufacturer.

Page 3 from 3Page 2 from 3930058000_09_004930058000_09_004
10 A protection fuse
of the
control unit and the
card switch
The protection fuses
of the light and A/C
circuits depends on
the loads.
LNN
L1
L2
NONO CC NCNC
Card switch
Light and A/C control
RF-85
L
N
230V AC
25A
230V AC
25A
Light
circuit
230V AC
25A
230V AC
25A
Cable type
Depends on the load
(maximum permissible
diameter 6mm)
BB
ΑΑ
--
WINWIN
++
Windows magnetic contact
(BS-429)
CC
NONO
A/C circuit
Cable type
2 x 0.75 to
2 x 1.5
Cable types
4 x 0.50
Terminals for
connecting the
card switch
RF-85
Cable type
2 x 0.50 to
2 x 0.75
Figure 4
RF-58
++ -- AA BB
Cable type
Depends on the load
(maximum permissible
diameter 6mm)
The light source contained in this luminaire shall only be replaced by the manufacturer, or
his agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical
leaflet, which accompanies each product. This warranty ceases to exist if the buyer does not follow
the technical instructions included in official documents given by Olympia Electronics or if the
buyer modifies the goods provided or has any repairs or re-setting done by a third party, unless
Olympia Electronics has fully agreed to them in writing. Products that have been damaged can be
returned to the premises of our company for repair or replacement, as long as the warranty period
is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not
charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to
charge or not the buyer the transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Eginio Pierias Greece
www.olympia-electronics.gr