6 7
2. Place the device over the desired treatment area.
Ensure that the electrodes are in contact with the skin.
3. Press the power button on the Wireless host. Blue
lights will activate.
4. Press the remote contol's power button.
The light will be on and the device will be set to Mode 1
by default. This unit has 6 modes. Once the host device
is successfully connected to the remote control, the Wi-Fi
symbol will display on the remote control screen. If the
remote control is not operated or connected within two
minutes, it will automatically power down.
5. Treatment will end on its own after 30 minutes.
Treatment can be stopped anytime by pressing power
button on the host or remote control. DO NOT attempt to
remove the device from the body during treatment.
6. Set the Mode. Press the “M” button on remote control to
set the mode or quickly tap the power button on the host
device and then set the mode. For safety, when the mode
is changed, the intensity will automatically decrease to the
lowest setting. To Change the Intensity: On the host or
remote device, press the “+” to increase intensity or the”-”
button to decrease intensity.
7. Time setting. Press remote's "T" button to set time.
Treatment can be set between 10-60mins in increments of
10 mins. Pause Unit: Press the on remote control to
pause and/or continue the treatment.
7. To safely power off device during stimulation, you may
long press the power button on the remote control or
press and hold the power button on the host device for 3
seconds. Replace protective film over electrodes to store.
Note:
1. The control unit is compatible with all Omega Wireless
Pads.
2. When host is used by itself the remote control can be
added mid-treatment, and the strength will reset to the
default starting value after the remote is connected.
Unit Storage & Maintenance
•Use a damp cloth with mild soap to gently wipe down
and clean the unit.
Note: This unit has water detection technology. Do not
expose or submerge this unit in water or any other liquids.
Water damage to the device or its components will void
the warranty.
• This unit should be operated, transported and stored at
temperatures between 50° F and 104° F (10° C and 40°
C), with relative humidity between 30% - 85%. All values
have+/- 10% tolerance.
• Store the device, remote control, and electrodes in
original packaging between treatment sessions.
