OMEGAbilance FREESTYLE Compact Lite CS Series User manual

g.9 FREESTYLE Compact Lite CS / PL series
Connector panel POWER CORD
NOT INCLUDED
kit for transformation into a walking versioncod. MPZ752E
For external power supply 25Vdc
We thank our users for choosing an OMEGAbalance product, for further
information and details visit the website www.omegabilance.it
WARNINGS
The manufacturer cannot be held responsible under any circumstances for any damage or loss resulting from
improper use of the components.
Incorrect installation of this product, including inadequate fixing, contrary to what is specified in the
instructions, can lead to malfunctions.
Before carrying out the work, make sure that the power cord is disconnected.
Perform the operation with an antistatic bracelet.
Observe the polarity
indicated on the PLUG
CONNECTION TO EXTERNAL POWER SUPPLY
Connect to external 24Vdc power supply (cable not included)
CONTENTS OF THE KIT
- connections board ver. itinerant code:MPZ752F
- 500mm walking battery cable code:MPZ1072
- external plug code:MPM476
- instructions
(WITH "T" HANDLE)
g.1 g.2
Omega Bilance Srl
Single-member company
Via Bettolino, 1721013 Gallarate (VA) Italy Tel:
[phone] [email protected]
www.omegabilance.it
X2
x10
ACCESS TO THE CONNECTIONS CARD
(1) Remove the plate and the cross, unscrewing the two Allen screws with a D5 wrench (with "T" handle)
(2) Remove the top closing frame, secured with the 10 M4x10 screws.
4All information contained in this guide may be subject to changes by OMEGAbilance srl without prior notice. 1
Translated from Italian to English - www.onlinedoctranslator.com

g.3 g.6 g.7
Connections tab
Logic board
X4
(There) (B ') (B)
(C)
(TO')
(TO)
(D)
CONNECTIONS
(6) - (7) After fixing the board, proceed with the connections (A, B, C, D) as shown in the figure.
(a) MPZ766 LAN cable
(b) MPZ756 FLAT cable
(c) MPZ1072 walking battery cable (new cable included in the kit). Make sure
that the cable does not interfere with mechanical components.
REMOVAL OF THE MPZ752C CONNECTION BOARD
(3) Gently disconnect the connections on the board and remove it from the "slot" by unscrewing the 4
M3X6 screws (including ground connection).
(d) grounding.
g.4 g.5 6
g.8 REPOSITIONING FRAME OF
COVER AND CRUISE
Apply the upper closing frame, fixing it
with the 10 M4X10 screws.
Then insert the spider, and fix it with
the two 6X25 Allen screws previously
removed.
Re-test the product.
INSERTION OF THE AMBULANT CONNECTION CARD cod. MPZ752F
(4) - (5) Insert the itinerant connection card cod. MPZ752F in the guides on the base, (before
inserting the card it is recommended to connect the cable "C") and proceed with fixing, using
the 4 screws, previously removed -restore the earthing in the same position.
23