support@omnisense.com 1.805.340.9625
Page 5OmniSense G-3 Series Gateway
8. Connecting G-3 Gateway to the internet
To view your data in real time your gateway must have a internet
connection. The G-3 can connect using Cellular (on G-3-C
models), WiFi or hard wired Ethernet connections. Follow the
steps in this section to connect the G-3 to the internet. To use
your G-3 gateway in datalogging mode see section 9.
power on gateway as described in section 5
follow the steps in either section 8.1, 8.2 or 8.3
depending on your method of connecting to the internet, to
establish an internet connection
If you have a internet connection then after a delay of up to
60 seconds you should see the "Internet" LED go on
solid
if the Internet LED does not go on the gateway is not
talking to our server and your internet connection is not
working. Check the troubleshooting guide in section 15
and/or our web site forum at shop.omnisense.com for
troubleshooting tips.
8.1. Wired Ethernet Internet Connection
Typically this is zero configuration and you do not need to
access the G-3 Management Web Page when using a wired
Ethernet connection
Connect the gateway's WAN/LAN Ethernet port using the
supplied Ethernet cable to your LAN, router, cable modem,
DSL modem etc. to establish an internet connection
You should see the "WAN/LAN" Link LED go on solid or
blinking
8.2. WiFi Internet Connection
login following instructions in section 7
Mouse over the "Network" drop down menu and click on
"WiFi"
click "Scan" and you should see a list of available wireless
networks
Click "Join Network" for the network you wish to join
If the network you are joining uses wireless security then on
the next page " Join Network: Settings" enter the "WPA
passphrase" then click "Submit".
On the next page do not change any of the default settings.
Scroll down to the bottom and click "Save & Apply"
