FINAL ASSEMBLY
1. Locate the telescoping platform and make sure it is in its
narrowest position. If necessary, loosen the cat’s-eye
knobs to adjust the platform width.
2.Place the at side of the platform on a level surface.
Line up the large holes at the top of the height-adjusting
column inside the brackets on the platform.
3. Insert a long screw through the holes closest to the
platform. Secure the assembly with the included washer
and bolt. Use a 13mm hex socket wrench or 13mm open
end wrench to tighten gently. Leave the joint loose
enough to adjust the tilting angle, but tight enough to
keep the screw in the square anti-rotation cut out.
ASSEMBLE THE TELESCOPING PLATFORM AND HEIGHT-ADJUSTING COLUMN
5. STEP 1) Insert the platform/column assembly into the
base/column assembly as shown. Note that the platform
and base are parallel and the front of the platform is the
side with the upturned tabs.
STEP 2) Locate the height adjustment knob and the
security pin. Tether the security pin strap by capturing its
ring between the height adjustment knob and the welded
nut at the top of the main column. Tighten the height
adjustment knob just enough to keep it in place.
STEP 3) Lift the height adjustment column to the desired
height and insert the security pin into the corresponding
hole as shown. Tighten the height adjustment knob to
complete assembly.
4. Insert the other long screw through the slots in the
brackets and the matching holes in the column. Secure
with a washer and the included knob.
Note:This knob allows for tilt adjustment and should be
placed on the right side for right-handed players or on the
left side for left-handed players. The front of the tray can be
identied by the two upturned tabs.
For more detailed instructions, visit: On-Stage.com
