on stage LSA7700P User manual

ASSEMBLY INSTRUCTIONS
LSA7700P
READ THIS MANUAL CAREFULLY BEFORE ASSEMBLING AND USING THIS
PRODUCT. KEEP THIS MANUAL IN A SAFE LOCATION FOR FUTURE REFERENCE.
WARNING
1. Take one lighting arm, and position its clamp on the upper
vertical shaft at the desired height.
2. Look at the clamp label and be sure the clamp is right side up.
3 . Check to ensure the vertical shaft is fully inside the clamp
opening (See figure A).
4 . Tighten the large steel knob at the end of the clamp.
5 . Repeat with the other lighting arm. Both clamps should be
right side up (See figure B).
POSITIONING THE CLAMPS WITH THE LABELS UPSIDE DOWN
WILL CAUSE THE ARMS TO SAG.
IMPORTANT
ALWAYS MAINTAIN A BALANCED STAND. THE CLAMPS SHOULD
BE POSITIONED 180° APART FOR STABILITY AND SAFETY.
CAUTION
Vertical shaft must
be fully inside the
clamp opening
Fig. A
Fig. B
Congratulations! You have purchased the
LSA7700P u-mount Lighting Arms. You’ll find
this system to be the fastest and easiest way
to add lights to your existing speaker or
lighting stands. With proper care, these arms
will last for years to come.
We hope you enjoy your
new purchase!
LIGHTINGARMS
®
Your LSA7700’s are pre-assembled and ready to use right
away. Set up your speaker or lighting stand following the
manufacturers recommendations, then follow the steps below:

Fig. C
Tighten 2nd
IF needed.
Tighten 1st
IF needed.
6. Check to ensure hardware is facing in the proper direction
for LED/PAR assembly, and that all knobs are tight. If knobs
are loose, or need to be loosened to adjust direction of
hardware, be sure to tighten the bottom knob FIRST
followed by the top knob, for each lighting arm before
proceeding to the next step (See figure C).
7. Mount your LED/PAR lights to each Lighting Arm using the
included hardware. Start from the inner-most positions and
work your way outward to maintain balance.
8. Connect electrical cords to your lights.
9. If applicable, follow the instructions to finish assembly of
your lighting stand or speaker stand, and enjoy your new
light show.
PLEASE KEEP THIS INSTRUCTION SHEET HANDY FOR FUTURE REFERENCE.
®
REGISTER ONLINE. HERE’S WHY:
Lightning Fast Service - Get the fastest turn-around in the
unlikely event of a warranty claim.
Product Notifications - We can contact you directly with
product notifications and safety information.
Better Products - Your registration helps us to improve our
products and develop new ones.
On-Stage.com
Model #LSA7700P
© 2013 TMP, Inc.
www.onstagestands.com