ASSEMBLY INSTRUCTIONS
LPT6000
Multi-PurposeLaptopStand
Congratulations on your purchase of the LPT6000 Multi-Purpose Laptop Stand. Please read
the following assembly instructions carefully. We hope you enjoy your new purchase!
Parts
Tools needed: Philips head screwdriver.
Remove all parts from boxes and identify:
SupportAssembly
1. Take one of the Upper Supports and place it
over the outside of one of the Lower Supports
(See Figure A). Align the Upper Support holes
with the Lower Support mounting holes to obtain
the desired height.
2. Place one knob at a time through the mounting
holes (must be spaced at least 2 holes apart).
3. Take a Stabilizer Bar and screw the top knob
into the end of the Stabilizer Bar. Repeat with
bottom knob.
4. Install 1 inch spacers on each Stabilizer bar to
increase stand width. Repeat Step 3 with the other
Upper Support and Lower Support for the opposite
side of the stand (see Figure B). Secure all knobs
tight to minimize stand wobble.
Upper
Support (2)
Lower
Support (2) Stabilizer
Bar
(2)
Figure A
Figure B
Place Upper
support over
Lower support,
so that the
Upper Support
is on the
outside
of the stand
Knobs must
be spaced at least
2 holes apart
Flat
Foot
Bar
(2)
2
Washers B
(4)
Knobs
(4)
Screws B
(4)
Washers A
(8)
Screws A
(8)
C-Clamps
(2)
Spacers
(2)
