on stage MY950 User manual

MY950
Mic / Antenna Bar
Assembly Instructions:
(1) threaded insert (2) security lugs
If any parts are missing, please contact On-Stage customer service.
Components Included:
(1) center bracket with 5/8”-27
female threading
1. With the mic bar track facing up, slide the
threaded insert into the end of one of the mic
bars until two of the insert’s holes are inside the
bar, leaving the other two holes exposed.
2. With the socket of the center bracket facing
down, slide the center bracket over the threaded
insert and mic bar.
(2) 24” mic bars
(1) speaker stand adapter (2) center bracket mounting lugs with
5/8"-27 male threading
(4) multi-position mounting lugs with
5/8"-27 male threading
3. Slide the second mic bar into the opposite end of
the center bracket so the threaded insert slides into
the end of the mic bar as in step 1. Push the two mic
bars together until they meet in the center. Align the
four holes of the threaded insert with the four holes
of the center bracket.

4. Depending on your desired mic/antenna
position, screw the two security lugs into either
the two inner or the two outer holes of the
bracket and threaded insert.
8. (a) To mount the
mic bar on a mic
stand, align the socket
of the center bracket
with the threaded end
of the mic stand shaft.
Screw the mic stand
shaft into the socket.
7. Repeat step 6 for the
remaining three multi-position
mounting lugs.
6. Loosen one multi-position mounting lug by turning the upper knurled cylinder counterclockwise until the
lower sliding block can travel freely through the mic bar. Insert the lower sliding block into the end of the mic
bar, leaving the metal washer above the mic bar track so that the lower sliding block is the only part inside the
bar. Slide the mounting lug to your desired mic/antenna position and tighten the mounting lug by turning the
upper knurled cylinder clockwise to secure it in place.
Questions or Concerns? Contact the Customer Service Department at [email protected] or call us at 800.289.8889
5. Screw the two center bracket mounting
lugs into the remaining two holes of the
center bracket and threaded insert
8. (b) To mount the mic
bar on a speaker stand,
screw the speaker stand
adapter into the socket of
the center bracket. Slide
the socket of the speaker
stand adapter over a 1
3/8” speaker stand pole
mount and tighten the
knob on the adapter.
9. Mount mics (clips not included), antennas, or anything
with a compatible 5/8”-27 threaded base to the six
mounting lugs. Reference the weight capacity of the mic
stand or speaker stand to avoid overloading.