OpenEye OE-C7022-APW User manual

Camera
OE-C7022-APW
OE-C7022-FPW
www.openeye.net
Outdoor Repositionable IP Dome Camera
User Manual
Accessories
CA-510G
CA-510W
CA-510C
CA-510P25
CA-510P50
CA-510PML
CA-510PMS
CA-510PA25
CA-510PA50

2

32953AA 3
Outdoor Repositionable IP Dome Camera (OE-C7022-FPW / APW)
User Manual
Manual Edition 32953AA –AUGUST 2014
©2014, OPENEYE
All Rights Reserved.
No part of this documentation may be reproduced in any means, electronic or mechanical, for any
purpose, except as expressed in the Software License Agreement. OpenEye shall not be liable for
technical or editorial errors or omissions contained herein. The information in this document is
subject to change without notice.
The information in this publication is provided “as is” without warranty of any kind. The entire risk
arising out of the use of this information remains with recipient. In no event shall OPENEYE be
liable for any direct, consequential, incidental, special, punitive, or other damages whatsoever
(including without limitation, damages for loss of business profits, business interruption or loss of
business information), even if OPENEYE has been advised of the possibility of such damages and
whether in an action or contract or tort, including negligence.
This documentation is copyrighted. All other rights are reserved to OPENEYE. OPENEYE, and
OpenEye, are registered trademarks of OPENEYE in the United States and elsewhere; Windows,
and Windows XP Embedded are registered trademarks of Microsoft Corporation. All other brand
and product names are trademarks or registered trademarks of the respective owners.
OPENEYE
Liberty Lake, WA ●U.S.A.

4
Important Safeguards
1. Read Instructions
Read all of the safety and operating instructions before using the product.
2. Retain Instructions
Save these instructions for future reference.
3. Attachments / Accessories
Do not use attachments or accessories unless recommended by the appliance
manufacturer as they may cause hazards, damage product and void warranty.
4. Installation
Do not place or mount this product in or on an unstable or improperly supported
location. Improperly installed product may fall, causing serious injury to a child or
adult, and damage to the product. Use only with a mounting device
recommended by the manufacturer, or sold with the product. To insure proper
mounting, follow the manufacturer's instructions and use only mounting
accessories recommended by manufacturer.
5. Power source
This product should be operated only from the type of power source indicated on
the marking label.
Precautions
Operating
Before using, make sure power supply and others are properly connected.
While operating, if any abnormal condition or malfunction is observed, stop using the
camera immediately and then contact your local dealer.
Handling
Do not disassemble or tamper with parts inside the camera.
Do not drop or subject the camera to shock and vibration as this can damage camera.
Care must be taken when you clean the clear dome cover. Scratches and dust will
ruin the image quality of your camera. Do not use strong or abrasive detergents
when cleaning the camera body. Use a dry cloth to clean the camera when it is dirty.
In case the dirt is hard to remove, use a mild detergent and wipe the camera gently.

32953AA 5
Installation and Storage
Do not install the camera in areas of extreme temperatures in excess of the allowable
range. (14°F~ 122°F / -10°C ~ 50°C)
Avoid installing in humid or dusty places. The relative humidity must be below 90%.
Avoid installing in places where radiation is present.
Avoid installing in places where there are strong magnetic fields and electric signals.
Avoid installing in places where the camera would be subject to strong vibrations.
Never face the camera toward the sun. Do not aim at bright objects. Whether the
camera is in use or not, never aim it at the sun or other extremely bright objects.
Otherwise the camera may be smeared and damaged.
Regulation
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Compliance is evidenced by written declaration from our suppliers, assuring that any
potential trace contamination levels of restricted substances are below the maximum level
set by EU Directive 2002/95/EC, or are exempted due to their application.

6
Warning
DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE.
DO NOT OPEN THE CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
Caution
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
C A U T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN

32953AA 7
Introduction .....................................................................................................................................9
Overview ......................................................................................................................................9
Product Features .....................................................................................................................9
Getting Started ..............................................................................................................................10
Box Contents..............................................................................................................................10
Camera Overview.......................................................................................................................11
Camera Diagram....................................................................................................................11
Camera Dimensions ..............................................................................................................12
OE-C7022-APW................................................................................................................12
OE-C7022-FPW................................................................................................................12
Connections...........................................................................................................................13
Indoor Cameras ................................................................................................................13
POE Power Source......................................................................................................13
12vDC Power Source...................................................................................................14
Locate Camera...............................................................................................................................15
OpenEye Network Camera manager..........................................................................................15
Installation..............................................................................................................................15
Starting Network Camera Manager........................................................................................15
Device Addressing.................................................................................................................16
Finding Network Devices ..................................................................................................16
Setup & Configuration ..................................................................................................................17
Connecting to the Camera..........................................................................................................17
Resetting the Camera............................................................................................................17
Administrator/User Privileges.................................................................................................17
Connecting a Stream.............................................................................................................18
Connecting Over the Internet.................................................................................................19
Viewer Software .........................................................................................................................20
Viewer Tabs...........................................................................................................................20
Live ...................................................................................................................................21
Setup.................................................................................................................................22
Advanced..........................................................................................................................23
System.........................................................................................................................23
Network........................................................................................................................24
Advanced Network Setup.............................................................................................26
Security........................................................................................................................27
Mail...............................................................................................................................29
Alarms..........................................................................................................................30
Storage Management...................................................................................................31
Scheduled Recording...................................................................................................32
Maintenance.................................................................................................................33

8
Software.......................................................................................................................34
System Log..................................................................................................................36
Remote Backup............................................................................................................37
Exposure......................................................................................................................38
Camera Setup..............................................................................................................39
Motion Detection ..........................................................................................................41
Stream..........................................................................................................................42
Audio............................................................................................................................44
Logout...............................................................................................................................45
Specifications................................................................................................................................46
Camera Specifications................................................................................................................46

32953AA
The OpenEye Outdoor Fixed IP cameras are capable of providing real time streaming
video with smooth image quality. The IP Mini Dome cameras offer quad streaming and
can be used in a variety of installations including shops, stores, banks, parking lots,
factories and for building surveillance.
With Power over Ethernet (PoE) the need for separate power lines is eliminated and
cabling and installation costs can be significantly reduced. The light weight, small size,
and large degree of rotation of the IP Mini Dome facilitates quick and simple installation on
either the ceiling or walls of structures or vehicles.
Product Features
Motorized Repositionable For Easy Adjustment
ONVIF Compliant, Profile S
1080p (2MP) Resolution
30 IPS at all resolutions
1/2.8” COMS Sensor
True Day/Night with IR Cut Filter
True Wide Dynamic Range
3D-DNR (3D Digital Noise Reduction)
Motion Detection
1 Sensor Input, 1 Sensor Output
Micro SD/SDHC Card Slot (Card Not Included)
Power Over Ethernet(PoE) & DC12V

10
Before proceeding, please check that the box contains the items listed here. If any item is
missing or has defects, DO NOT install or operate the product and contact your dealer for
assistance.
Camera (FPW or APW)
Mount Plate & Torx Tool
Screws & Plastic Anchors x 3
Mount Bolt & Nut x 2
Bolt & Nut Template Sheet
Mount Plate Template Sheet
Software CD / Documents

32953AA 11
Before installing or connecting the dome camera, please refer to this section and complete
preparations for dome setup and all switch settings.
Camera Diagram

12
Camera Dimensions
Width: 4.9”
Height:
3.25”
Width: 4.9”
Height:
2.9”

32953AA 13
Connections
The camera is compatible with 12vDC and Power over Ethernet (PoE). Connect power to
the camera using the provided power connector lead or connect the camera to a PoE
power source. If you are connecting 12vDC power, verify the polarity of the power
connection. If you are using PoE, make sure the Power Sourcing Equipment (PSE) is in
use in the network.
Check the status of the network connection by looking at the link indicator and activity
indicator LEDs. If the LEDs are not lit check your network connection. The green link LED
indicates a network connection and the orange activity LED flashes to indicate network
activity.
POE Power Source
PoE allows for the transmission of power and data via a single Ethernet cable. PoE
eliminates the need for multiple cables to support power and recording. Follow the
installation below to connect the camera to a PoE-enabled switch using an Ethernet cable.

14
12vDC Power Source
If PoE is not being used, a power adapter is needed to power the camera. An additional
12vDC connector cable is required.
PoE
12vDC power

32953AA 15
Use the included Network Camera Manager software to easily find your network cameras
for initial setup. Network Camera Manager software is included on the CD with all
OpenEye IP devices.
Installation
You can install Network Camera Manager on any personal computer (PC) or laptop using
the software CD included with your OpenEye IP camera or by downloading the program
from openeye.net.
Network Camera Manager will only work on PCs or laptops that use a Windows
operating system. It is compatible with Windows XP, Vista, 7, and 8.
Starting Network Camera Manager
After installing the program on your PC or laptop, open the program to begin configuring
your cameras.
To access Network Camera Manager on an OpenEye recorder, you must operate the
recorder in Windows Mode.
1. In the Live Screen, click Exit.
2. Click Restart in Windows Mode.
3. Click OK.
4. Double-click Network Camera Manager.

16
Device Addressing
The functions on the Device Addressing tab allow you to find, configure, and view network
cameras.
1. Click Find Devices on the Device Addressing tab.
2. To narrow your search by Camera Model, Project, or Camera Name, select
your desired criteria from the appropriate lists.

32953AA 17
1. Locate the camera on the IP Finder list.
2. Double-click the camera to open the Viewer software in your web browser.
3. Click Browse in the pop-up window.
4. Log in to the camera with the appropriate User Name and Password.
The default User name is admin and the default Password is1234. The
username and password are case sensitive.
Resetting the Camera
If it is necessary to reset the camera to the factory default settings, hold down the Reset
button (see Camera Overview) for 30 seconds. This will return all settings, including
network setup, to the factory default.
Administrator/User Privileges
The Administrator account has the authority to configure the IP camera and authorize
users’ access to the camera. The User accounts have access to the camera with limited
authority.

18
Connecting a Stream
OpenEye IP cameras are optimized for use with OpenEye recorders, but you can also
connect to your OpenEye IP cameras using third party software like VLC media player
(http://www.videolan.org).
To connect the camera you may need to provide the stream URL. All OpenEye IP
cameras are capable of delivering two RTSP streams, as well as streaming MJPEG over
HTTP. The stream URLs are listed below.
rtsp://<ip address>/mjpeg
rtsp://<ip address>/mpeg4
rtsp://<ipaddress>/h264
http://<ipaddress>:8008
1. Click the Advanced tab.
2. Click Network Setup under the System Setting menu.

32953AA 19
Connecting Over the Internet
There are some challenges with connecting to OpenEye IP cameras over WAN (internet)
connections because the camera streams video over RTSP. RTSP is an excellent
protocol for media and is now used on many IP cameras (including OpenEye) as the
default streaming option.
However, RTSP is not suitable for transmission between two locations that are behind
different routers. In this case, the client (for example, the OpenEye HVR or NVR server
software) connects to the camera, then requests a stream. The camera uses that
connection to return a stream, but since the connection originated on the client side and
has now switched to the camera (remote) side, the router does not have any way to
determine where the traffic should be routed, so no video appears at the recorder.
There are three solutions to this:
Connect modems on both sides directly to the recorder and camera. If there is no
router, no network address translation is needed.
Use routers with VPN support and set up a small VPN. Once this is done, the traffic
will be treated as though it were all on the local network.
(Best solution) –Use routers with connection tracking. This is quite easy; VOIP
also uses RTSP and faces the same challenges. If a router is marketed as having
“VOIP Support”, it will have the necessary connection tracking capability to allow any
type of RTSP communication (not just VOIP).
With proper planning and the correct equipment, RTSP cameras CAN stream over the
WAN to a recording device for minimal additional cost and labor.
Please contact OpenEye support if you require any additional information on these topics.

20
To access the setup menu, you need to install the viewer software on your PC or recorder.
The viewer software will install automatically the first time you connect to the camera. If
your internet browser doesn’t install the viewer software, check the security settings or
ActiveX controls and plug-in settings. If your internet browser asks for permission to install
the ActiveX control, you must allow the ActiveX control to continue the installation.
The first time you connect to a camera, the browser will ask for permission to install the
ActiveX Control necessary to display the camera video. Right-click the information bar and
click Install ActiveX Control to allow the installation.
IP camera audio is only available on the Indoor IP mini dome camera. The Talk
button will not be available on the Outdoor version of the camera.
Viewer Tabs
Live –Monitor video and perform other video related functions.
Setup –Set the camera name, IP address, and define users. This tab also allows you to
configure the camera settings and view streams.
Advanced –Perform advanced setup configurations, like network setup, security, alarms
and maintenance.
Logout –Change user.