Operative Experience Tactical Hemorrhage Control Trainer User manual

1Equipment Identification
+Simulator +Battery Pack
and Charger
2Charge Battery
+Plug into a standard electrical outlet. The red light
indicates charging.
+Charge the batteries for 6 to 8 hours (or overnight).
The indicator light turns green when the batteries
are fully charged.
+To install the battery pack, remove the skin cover on the
upper left thigh to access and open the compartment.
Then, attach the pack to the connector, and after resetting
the pack in the compartment, close the compartment
and replace the skin.
3Install Battery
QUICK START GUIDE
+Fill the reservoir on the hand pump with simulated blood.
+Lift the penis and extend the blood fill port.
+Attach the blood fill hose by snapping onto the blood fill
port on the simulator located under the penis. (Be sure the
hose nozzle if free of debris.)
+Retract the handle and pump approximately three times or
until the simulator’s blood reservoir is full.
4Add Blood to the Simulator
To get started, please follow these easy steps:
Tactical Hemorrhage
ControlTrainer
+Hand Pump
(for blood)

operativeexperience.com | 500 Principio Parkway West, Suite 900 | North East, MD 21901 | 410-287-5748 © 2018 Operative Experience, Inc.
Questions and Support
Contact us if you have a question or need help
with your simulator.
Phone: [phone]
Email: [email protected]
+Use the remote“key fob”controller to turn the blood
flow on and off.
+Flip the switch to the right underneath the skin in the back of
the neck.
+Allow simulator to cycle through the powering up sequence
5Powering On 6Running the Blood
QUICK START GUIDE
Tactical Hemorrhage Control Trainer