Oplink DGL1130 User manual

Oplink Communications
1 / 3
DGL1130 User Guide
I. Product Introduction
DGL1130 is a kind of 433MHz wireless signal transceiver, using for receiving and
transmitting control signal from its matched devices, matched devices are products
which can transfer control signal remotely, such as alarm systems, door openers,
remote switches etc.
System Structure

Oplink Communications
2 / 3
II. Installation & Workflow
DGL1130 has an USB port, it is plug and play and no installation or configuration
work needed. Please plug the USB port to the computer or other recognizable
devices and it will start to work.
1) When the sensor, which should be matching its system, is triggered, the DGL1130
will receive a 433MHz hex string signal.
2) DGL1130 will transmit the signal to the host device (like a matching Router or AP).
The signal will be processed by a software client and transferred to alert
information to end user
3) And at the same time, DGL1130 will send out a 433MHz hex string control signal
to the Siren. The siren will receive the control signal and start to work.
4) End user could stop the siren through software client.
III. User Instruction
Please plug the USB port to the computer or other recognizable devices and
power on.
Cautions：
1) LED Indicator
LED light will be permanently on in blue once it is powered up.
LED light will glint once per frame when transmitting wireless signal succeeds.
No special LED indication for receiving wireless signals.
2) Signal Emission
This product does not transmit signal periodically, and, will transmit control
signal to the alarm system only when sensors are triggered.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.

Oplink Communications
3 / 3
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.