Opus OP-LRM User manual

OP-LRM
OP-LRM
Prothesie simpulator for loop amplifier with headset
USER MANUAL

2
1- Product Overview
Opus Loop Receiver Mesurer is the most compact loop listening device on the
market.It allows anybody to listen to an audio frequency induction loop system
just like they were wearing an hearing device switched to the « T » position.
Uses include:
•Check the sound source of amagnetic loop.
•For hard of hearing not equiped with hearing aid to be able to hear the loop.
•Equiping aperson with hearing loss whose prosthesis does not have a"T"
position.
2- Components:
OP-LRM User manual |Prosthesis simulator for loop amplifier with headphones
English
Page 2

Page 3
3- Operation
The OP-LR loop mesurer is powered thanks to an internal battery.
1- Place the headset on your ears and adjust it for comfortable listening.
2- Adjust the volume aconfortable level by turning the volume clockwise until
acomfortable listening sound is obtained.Turn the knob in the opposite
direction to decrease the volume if necesseary and turn it off.
3- If the LED at the bottom of the device does not light, check that the internal
battery is correctly charged.
4- When you no longer need to use the device,turn the volume knob
counterclockwise until LED turns off.
Important
Store your headset when you no longer use it in order to extend battery life.
Always hold the hearing loop tester at ear height and upright when listening
to aloop system to ensure the best performance.
2
OP-LRM User manual |Prosthesis simulator for loop amplifier with headphones
English

4
4- Maintenance
To extend your OP-LRM life, make sure to carry out the following
recommendations regulary:
Clean with adry soft tissu, or cleaning wipes. Do not use solvent-based cleaners
and make sure to avoid getting all kind of liquids enter into the loop listener.
Turns off the headset when not in use.
Keep the battery charged.
5- Troubleshooting
Symptom Possible fault Action
Ignition LED does
not light up.
1. The battery is
empty.
2. There is an internal
fault.
1. Connect the tester to a USB
charger.
2. Contact your dealer.
No sound in the
hearing loop
listener.
1. Sound is not loud
enough.
2. The tester is not at
an appropriate
distance to listen to
the loop.
3. The magnetic loop
does not work.
4. The headphone has
a problem.
5. Internal fault.
1. Turn up the volume.
2. Bring the hearing loop listener
closer to the loop.
3. Use another hearing loop
tester or listening systrem ( if
possible ) to make sure the
loop works. If no sound is
coming out of the loop,
contact your dealer.
4. Replace the headphone.
5. Follow step 3. If the soud is
heard with another device,
contact your dealer to
changer the hearing loop
tester.
2
OP-LRM User manual |Prosthesis simulator for loop amplifier with headphones
English
Page 4