Original BTC Walter Table Light User manual

Walter
Instruction Manual
Table Light
MADE IN BRITAIN
ORIGINALBTC.COM
[phone]
UNIT 21 / 22 AVENUE ONE, STATION LANE, WITNEY, OX28 4XZ, ENGLAND
Established in 1990, Original BTC manufactures relaxed, familiar lighting for traditional and
contemporary homes.
All products are hand-assembled in Oxford from high quality components, produced in the UK.

Walter Table Light
FT587 Walter Table Light Size 1
FT588 Walter Table Light Size 2
230V ac 50Hz
Adjusting Fitting
IP20
* Warm white (2700k) low energy lamps recommended.
** Wattage value provided as a guide to suitable lamps. Lower wattage than stated may be used.
*** Dimming performance may be unstable with LED bulbs. Please check with bulb manufcaturer.
Not suitable for use with CFL bulbs
Safety Instructions
Cleaning and Maintenance
These instructions are provided for your safety in order to prevent the risk of Fire, Electric shock or
Injury. Please retain for future reference. When fitting is in operation, some parts will become hot;
take care when using/handling.
- Ensure the lamp type and max wattage is followed- do not exceed. Take care not to overtighten
lamp.
- Do not touch the lamp (bulb) or lamp holder while in operation, as both become very hot.
- Turn off and unplug fitting, leaving lamp to cool before changing lamp. Dispose of old lamps
carefully.
- Adjust light fitting only when power to the fitting is off and has been left to cool.
- Never leave a fitting without a lamp in position.
- Keep light fitting away from combustible materials such as soft furnishings.
- Ensure children do not play with the light fitting.
- Ensure the light is positioned on a solid, level and non-slip surface and make sure the position of
the cable does not pose a trip hazard.
- If the electrical flex or electrical components become damaged at any point, the fitting must be
unplugged from the power supply immediately and not operated until the damaged parts are
fixed/replaced.
- For use in a dry, indoor environment only. Ensure the fitting does not come into contact with any
liquids.
Metal finishes should only be cleaned with a soft, dry cloth. Do not use polishes or abrasives. Glass
can be cleaned by hand, using a soft damp cloth with a diluted mild detergent (nonabrasive) if
necessary. Switch off power to the fitting before cleaning.
The Walter Table Light has a unique 1960s feel, with a striking combination of satin copper
and either opal or anthracite glass shades. Our squirrel cage light bulbs complement the style
beautifully, as do the black cotton braided cable. The lights are available in 2 sizes and they
have an integral dimmer on the base.
E27 GLS BALL
LAMP GUIDANCE
TYPE* WATTAGE** BASE SHAPE




INCANDESCENT
CFL
ECO-HALOGEN
LED***
60W MAX
-
42W
10W
When handling the light, always support from below - do not lift from the glass.
1. push knob to toggle light on/off
2. twist knob to vary light intensity
!
Glass shade installation
Rubber washer
TOP VIEW
Thumb screw - DO NOT OVERTIGHTEN
Locate all three screws before gently
tightening a little at a time.