ORION TELESCOPES & BINOCULARS AutoTracker 8976 User manual

Orion AutoTracker™Tripod
#8976
IN 490 Rev. A 05/13
INSTRUCTION MANUAL
Congratulations on your purchase of a quality Orion product.
These sturdy aluminum tripods provide solid support for your
AutoTracker mount and are designed for either indoor or out-
door use.
To get the most from your new tripod, please take a few min-
utes to read these instructions.
Refer to the labeled gure for the names of specic parts of
the tripod.
Corporate Offices: 89 Hangar Way, Watsonville CA 95076 - USA
Toll Free USA & Canada: [phone]
International: [phone]
Customer Support: [email protected]
Copyright © 2021 Orion Telescopes & Binoculars.All Rights Reserved. No part of this product instruction or any of its contents
may be reproduced, copied, modied or adapted, without the prior written consent of Orion Telescopes & Binoculars.
AN EMPLOYEE-OWNED COMPANY

2
Adjusting the Tripod’s Stance
Loosen the brace lock knob and open the tripod legs to their
widest position. Move tri-brace to bottom of shaft, and then re-
tighten the tri-brace lock knob in order to achieve best stability.
Adjusting the Legs
Your tripod comes fully assembled. Note that each leg has two
telescoping sections. To extend a leg, loosen the lever lock
knob, and then extend the leg. When it has been extended to
the desired length, tighten the lever knob back down.
Before mounting the AutoTracker mount on the tripod it is a
good idea to press down gently on the base plate to make sure
the legs are locked securely and will not give way under the
instrument’s weight.
Mounting the AutoTracker Mount onto the Tripod
Position screw hole underneath AutoTracker mount to meet
screw on top of base plate. Rotate mount to tighten screw.
Keep rotating until rmly attached. Once mounted the tripod
legs may need to be adjusted. Use the bubble level built Into
the AutoTracker mount to achieve precise leveling.
Raising and lowering the base plate
To raise or lower the base plate, rst loosen the elevator lock
knob. Then use the hinged hand crank to move the aluminum
rack-and-pinion elevator shaft up or down. Retighten the eleva-
tor lock knob to secure the instrument at the new height.
General Care and Cleaning
If the tripod is used in wet conditions, dry it completely with a
soft cloth after use. Clean the tripod with mild detergent and a
soft cloth.
Specifications
Height fully extended: 54.5"
Height folded: 18.5"
Weight: 4.2 lbs
Capacity: 13 lbs 2 oz
WARNING: Never look directly at the Sun with the naked eye or with a telescope – unless you have a proper solar
lter installed over the front of the telescope! Otherwise, permanent, irreversible eye damage may result.
Figure 1. The AutoTracker Tripod.
Elevator
lock knob
Base plate
Brace
lock
knob Lever
lock
knob
Hinged hand crank
Tri-brace
One-Year Limited Warranty
This Orion product is warranted against defects in materials or workmanship for a period of one year from the date
of purchase. This warranty is for the benet of the original retail purchaser only. During this warranty period Orion
Telescopes & Binoculars will repair or replace, at Orion’s option, any warranted instrument that proves to be defective,
provided it is returned postage paid. Proof of purchase (such as a copy of the original receipt) is required. This warranty
is only valid in the country of purchase.
This warranty does not apply if, in Orion’s judgment, the instrument has been abused, mishandled, or modied, nor
does it apply to normal wear and tear. This warranty gives you specic legal rights. It is not intended to remove or
restrict your other legal rights under applicable local consumer law; your state or national statutory consumer rights
governing the sale of consumer goods remain fully applicable.
For further warranty information, please visit www.OrionTelescopes.com/warranty.
Corporate Offices: 89 Hangar Way, Watsonville CA 95076 - USA
Toll Free USA & Canada: [phone]
International: [phone]
Customer Support: [email protected]
Copyright © 2021 Orion Telescopes & Binoculars.All Rights Reserved. No part of this product instruction or any of its contents
may be reproduced, copied, modied or adapted, without the prior written consent of Orion Telescopes & Binoculars.
AN EMPLOYEE-OWNED COMPANY