Osprey Robby 6000 Manual

Push down on pressure safety
cap then turn the cap
anti-clockwise to unscrew.
OPERATING PROCEDURE
The following rules must be observed when using the Robby 6000
 Always Check daily before use that the power supply cable, plug
and sockets are in good condition; check for visible signs of
damage (do not use if damaged)
 Never allow any part of the Robby 6000 to be immersed in
water
 Always Follow the correct procedure when filling the water
reservoirs and waste tank  Never allow children, inexperienced, untrained or
unauthorised people access to the Robby 6000
 Always Wear full PPE when working in confined spaces - mask,
goggles, gloves, overalls.
Push down on the tank cap and
turn it clockwise to screw it shut
firmly.
Switch on the main switch. The boiler ready lamp
(green lamp) will light up when ready for use.
Fill the tank with water using
the funnel : max. 4 ltr.
Preferably hot water. Make
sure the tank does not overflow.
Operating Procedures on the Robby 6000
Connect the steam hose
to inlet.
Now the machine is ready for
use: Activate the steam
switch.
When hot water is required switch on the right
switch of the pistol grip and the hot
water switch.
Select the required accessory. Push firmly
onto the left switch of the pistol grip and
the trigger (red switch underneath the
pistol grip). It is possible that a small
amount of water is released.
Open the steam output
regulator knob and regulate
it to the required amount of
steam.

"The buyer shall take responsibility for the environmentally safe and legal disposal of
the product at the end of life and in accordance with the requirements of the WEEE
Regulations 2006. In the case of the UK as described in Regulation 9 (2) of the WEEE
Regulations 2006 the buyer agrees to be responsible for providing disposal facilities
for non household products."
Refilling the boiler of the machine
When the low water level light
(orange light) lights up: fill up the
water tank.
Switch off the machine by using
the main switch De-pressure the boiler: Press the left switch of the pistol grip and
the trigger (red switch underneath the pistol grip), untill the pressure
gauge shows 0 bar.
Wait 2 or 3 minutes and fill up
slowly using the funnel. Push down on the tank cap
and turn it clockwise to
screw it shut firmly.
Switch on the main switch. The boiler
ready lamp (green lamp) will light up
And blink. When the lamp lights up
continuously, the machine is ready
Once the tank is de-pressurised
then using EXTREME CAUTION;
Push down on pressure safety
cap then turn the cap