Otto STORM User manual

STORM SPEAKER
MICROPHONES
• Contoured design for
easy handling
• One-meter immersion
rating
• Push-button volume control
• 2.5 mm earphone jack
• Clothing spring clip

1 2
STORM
INSTALLATION:
1. Turn radio off
2. Remove any dust caps or covers from radio accessory connector
3. Attach speaker microphone to the radio accessory connector
4. Tighten mounting thumbscrew, if required
Antenna versions only (Optional):
5. Remove antenna from 2-way radio
4. Attach antenna to the connector on top of the speaker microphone
OPERATION:
Turn the radio on and operate it as explained in the operating instructions
supplied with the radio. Installing the speaker microphone (1) bypasses
the radio’s speaker and routes the speaker output to the speaker micro-
phone and (2) disables the radio’s microphone and enables the speaker
microphone. To enable the microphone, press the large PTT actuator
located on the side of the speaker microphone.
Earphone jack
• Remove the protective cover from the earphone jack
• Insert the audio accessory with 2.5 mm plug into the earphone jack.
Audio will be muted in the speaker microphone and routed to
the accessory.
• CAUTION: to maintain the environmental seal, replace the
protective cover when the plug is not in use.
Volume Control Button
• Push the volume control button to high or low as required for your
application. The “In” position is high output and “Out” position is
low output.
Light Control Button (Optional)
• To turn light press “Off” or “On” button.
Note: Based on using a 1500 mah batter, one hour of Storm (lights on) operation is
equal to about 30 seconds of radio transmit time. Actual results will vary based on
battery condition and other factors.
Antenna versions only: (Optional)
The speaker microphone assembly will perform best when worn
above the shoulder.
Auxiliary Connector (Optional)
Contact factory for operating instructions.
STANDARD MIC. OR
NOISE-CANCELING MIC. OPTION
SEALED 2.5mm EARPHONE JACK
LED LIGHT OPTION
PUSHBUTTON
VOLUME CONTROL HIGH/LOW
IMPROVED STRAIN RELIEF
FOR BETTER FLEX LIFE
PUSHBUTTON LED
FLASHLIGHT OFF/ON
PUSH-TO-TALK
ANTENNA OR GPS ANTENNA POSITION
INDICATOR OPTION
PUSHBUTTON
EMERGENCY OPTION
AUXILIARY CONNECTOR FOR
OPTIONAL ACCESSORIES OR
PROGRAMMING CAPABILITIES

Information on Disposal of Old Electrical and Electronic Equipment (applicable
for EU countries that have adopted separate waste collection systems).
Products with the symbol (crossed-out wheeled bin) cannot be disposed
as household waste.
Old electrical and electronic equipment should be recycled at a facility
capable of handling these items and their waste byproducts. Contact your
local authority for details in locating a recycle facility nearest to you.
Proper recycling and waste disposal will help conserve resources while still
preventing detrimental effects on our health and the environment.
10 West Main Street • Carpentersville, IL U.S.A. 60110
Toll Free Phone: 888-234-OTTO (6886)
Phone: [phone] • Fax: [phone]
E-mail: [email protected]
www.ottoexcellence.com
804195 - Rev E
For warranty information, customer service
or replacement parts, please contact:
GPS (Optional)
Contract factory for operating instructions.
MAINTENANCE:
If necessary, the external surfaces of the speaker microphone may
be cleaned with a mild soap solution and warm water.
Optional Earphone Kits
Description Part Number
Earphone with Acoustic tube, 2.5 mm straight plug,
coil cord (30” extended length), black V1-10282
Earphone with Acoustic tube, 2.5 mm right angle
plug, coil cord (30” extended length), black V1-10432
Ear hanger, 2.5 mm right angle plug, coil cord,
(30” extended length), black V1-EH22R131