7
Long-Term Storage
For long-term storage of an unused system,
keep in a cool, dry location out of direct sunlight.
Long-Term Storage After Use
To store the system for more than a week after
active use, flush the system with at least
two gallons of clear water. Allow the Sleeve
Filter and Purifying Filter to dry completely.
Discard and replace the Rening Filter. Prior
to using after the storage period, clean the
Spigot and interior of the Purified Water
Container and flush the system with at least
two gallons of clear water.
Short-Term Storage After Use
To store the system for brief periods of less
than seven days after active use, flush the
system with at least two gallons of clear
water. Before resuming use, flush the system
once more after the storage period.
Storage
Operating conditions impact how often a system needs
to be cleaned. If you are using the system in a clean
seing, the system should be cleaned at least once a
week. Under more rugged conditions, clean your system
at least twice a week and discard any unused, puried
water stored for 72 hours or longer. Be sure to track your
usage to ensure proper filter replacement.
Cleaning Instructions
1.Using filtered water, rinse any dirt from inside the
Source Water Container.
2.With clear water, rinse the Net Filter, Sleeve Filter,
and Purifying Filter to remove debris.
3. Use a clean cloth dampened with a chlorine solution
to wipe the inside of the containers and Spigot. Use
½ teaspoon of household bleach (5.5 - 6% Chlorine
Hypochlorite) per 5 gallons of water.
4. Reassemble the system for operation.
5.Wipe away dirt or debris from the outside surface
and rinse with clean water.
NOTE:
*Except for the four lters, all surfaces can beexposed to hot, soapy water.
**Maintenance and storage according to the manufacturer’s instructions
are essential for the performance and safety of the filtration system.
Replace the lters according to the replacement schedule on page 8.
Maintenance
