Outland Living OLVG-332 User manual

FMI BRANDS INC. 101 – 3570 194 Street, Surrey, BC, Canada V3Z 1A5
USA, Canada Toll Free: 1-888-514-1663 | Tel: [phone] | Email: [e-mail]
Hours of Operation 8:30 AM - 4:00 PM (Pacific Time)
D.332.000.V0
Raised Garden Bed
Model number OLVG-332
® Registered trademark of FMI Brands Inc.
OWNER’S MANUAL
RAISED GARDEN BED

Owner & Safety Manual
En-1 D.332.000.V0
OUTLAND LIVING®- RAISED GARDEN BED - OWNER & SAFETY MANUAL
Model number OLVG-332
NOTE TO INSTALLER:
Leave this guide with the consumer.
NOTE TO CONSUMER:
Please retain this guide for future use.
WARNING:
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Read the
installation, operating and maintenance instructions thoroughly
before installing or servicing this equipment.
CAUTION:
Watch for sharp edges.
Wear protective gloves if necessary.

En-2
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SUPPLIED PARTS & HARDWARE LIST:
PART # DESCRIPTION PICTURE
5 Corner Post
(x4)
6 Corner Gusset
(x4)
7 M5 x 12 Screw
(x40)
8Hex Tool (x1)
PART # DESCRIPTION PICTURE
1 Long Bottom
Panel (x2)
2 Short Bottom
Panel (x2)
3 Long Top
Panel (x2)
4 Short Top Panel
(x2)

Owner & Safety Manual
En-3 D.332.000.V0
OUTLAND LIVING®- RAISED GARDEN BED - OWNER & SAFETY MANUAL
SECTION 1: ASSEMBLY
SETUP: Base Assembly
1a. Remove all components from the packing box. Identify
1 x short bottom panel (part 2) and affix the 1 x corner post
(part 5) using 2x M5 x 12 screws (part 7).
NOTE: The bottom panels are fixed to the lower holes on
the corner posts with the slots facing downwards
Slots facing downwards
1b. Identify 1 x long bottom panel (part 1) and affix to the
opposing side of the corner post using 2x M5 x 12 screws
(part 7).
Slots facing downwards
1c. Affix 1 x corner post (part 5) to the opposing end of the
long bottom panel using 2 x M5 x 12 screws (part 7)
Slots facing downwards
1d. Repeat these steps to attach all bottom panels.

En-4
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 1: ASSEMBLY (continued)
SETUP: Top Panel Assembly
2a. Identify 1 x short top panel (part 4). Slide the short top panel between the 2 corner posts. Using the (4) M5 x 12 screws
(part 7) to affix the short top panel to the (2) corner posts.
NOTE: The folded flange edge on the top panel should be facing downwards.
2b. Repeat this step to attach the remaining short
(part 4) and long top panels (part 3).

Owner & Safety Manual
En-5 D.332.000.V0
OUTLAND LIVING®- RAISED GARDEN BED - OWNER & SAFETY MANUAL
SECTION 1: ASSEMBLY (continued)
SETUP: Raised Garden Bed Assembly
3a. Attach corner gussets (part 6) to the panels. Use 2 x M5 x 12 (part 7) for
each gusset. Repeat 3 times.
Note: Corner gusset flange facing down.
SETUP: Raised Garden Bed Installation
4a. Locate the area where the garden will be installed.
4b. Fill with dirt. Plant. Enjoy. Harvest!
1224 mm
[48.2 in]
614 mm
[24.2 in]
400.5 mm
[15.75 in]

En-6
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 2: RAISED GARDEN BED
APPROXIMATE DIMENSIONS
The approximate dimensions of
the garden bed are
L 1224 mm x W 614 mm x H 400.5 mm
(L 48.2 in x W 24.2 in x H 15.75 in).
SOIL BUDGET
ASSUMPTION
Add your preferred type and
volume of potting soil mix. (Soil
not included). Plan your soil
budget for 284L (75 Gal) of soil
mix and/or adjust the volume of
soil to suit your need.
SOIL BUDGET
284 Litres (L)
75 US Gallon
10 cubic foot (ft3)
.37 cubic yard (yd3)
.28 cubic meter (m3)
SECTION 3: SET UP INSPECTION SEQUENCE
The raised garden bed should be inspected before use
and at least annually.
• Ensure no parts are missing and all fasteners are firmly
tightened.
This appliance is NOT a toy.
WARNING:
Do not climb on the Raised Garden Bed or use it as a step or
serious injury, property damage may occur.
1224 mm
[48.2 in]
614 mm
[24.2 in]
400.5 mm
[15.75 in]

Owner & Safety Manual
En-7 D.332.000.V0
OUTLAND LIVING®- RAISED GARDEN BED - OWNER & SAFETY MANUAL
STOP:
Do not return this product to the store.
If you need help or parts, call the OUTLAND Hotline:
1-888-514-1663
Get help for:
• Missing/damaged parts • Assembly • Troubleshooting
• Warranty Assistance • Product Information
1 YEAR LIMITED WARRANTY
Customers in Canada and USA
All components are warranted by the manufacturer for a period of 1 year after date of purchase by the original owner
against defects in materials and workmanship under normal use. This warranty does NOT cover normal wear and
weathering, assembly and/or maintenance OR use in a commercial application. At FMI Brands’ sole discretion,
products under warranty will be repaired and/or replaced at no charge to the customer. Any returns sent back to FMI
Brands must be sent via prepaid freight and in the original retail packaging.
Please register your OUTLAND Living product for proof of purchase and warranty at
https://outlandliving.com/register-products/
For more warranty information and details please contact FMI Brands Inc. at [e-mail]
FOR REPLACEMENT PARTS AND ACCESSORIES PLEASE VISIT
WWW.OUTLANDLIVING.COM
The owner’s manual is available as a free download from www.outlandliving.com
Should you have any questions or comments regarding this product, please do not hesitate to contact FMI Brands Inc. at [phone] or
E-Mail to [e-mail].