OverEZ Chicken Coop 46OEZCKCP User manual

O
N
E
T
O
O
L
R
E
Q
U
I
R
E
D

OverEZ!
Assembly is Watch our assembly video here
Place FLOOR in desired
location.
Important: Floor must be
level in both directions.
Place BACK WALL (A), making
sure wall is tight against oor
and ends of wall line up with
marks provided on oor.
Drive 4 pre-started screws on
the bottom.
Place CHICKEN DOOR GABLE
WALL (B).
Siding from BACK WALL will
slide into cavity provided. Make
sure wall is tight against oor.
Drive 3 pre-started screws on
corners, then drive 4 pre-started
screws into oor.
Install MAN DOOR GABLE WALL (D).
Siding from BACK WALL and FRONT
WALL will slide into cavities provided.
Make sure wall is tight against oor.
Drive 3 pre-started screws on corners,
then drive 4 pre-started screws into
oor.
Install ROOF PIECE (E).
(When viewing coop from back, E is
placed on left half of roof.)
Lower front edge of ROOF PIECE (E) onto
FRONT WALL rst, then lower back edge
onto BACK WALL.
Drive the 6 pre-started screws that are in
the top of the wall into the roof panel.
Install ROOF PIECE (F).
(When viewing coop from back, ROOF
PIECE (F) is placed on right half.)
Put black screw in bottom hinge of
door.
Drop ROOST BARS into slots provided
on inside of gable walls.
Hook CHICKEN RAMP at bottom of
chicken door.
step four
Place FRONT WALL (C), making sure
wall is tight against lower support wall.
Siding from FRONT WALL will slide
into cavity provided in CHICKEN DOOR
GABLE WALL.
Drive 3 pre-started screws on corners,
then drive 4 pre-started screws on
bottom.
step three
step two
step one
step eight
step seven
step six
step ve
Lower front edge of ROOF PIECE (F) onto FRONT WALL
rst, then lower back edge onto BACK WALL.
Important: ROOF PIECE (F) overlaps ROOF PIECE (E) at
the center of the coop.
Drive the 6 pre-started screws that are in the top of the wall into the roof
panel. Screw the 2 pre-started screws into the roof panel (E).
NOTE: To loosen or tighten door latches, use supplied allen wrench.
Loosen small screw on inside of latch with allen wrench, moving the
latch in or out. Tighten screw and test.
Find the bag with drill bits, keys, and touch up paint (to repair any mars on
pre-painted surfaces).
Please note: Actual product may differ slightly from instructional illustrations.