OverEZ Chicken Coop SOEZCKCP User manual

O
N
E
T
O
O
L
R
E
Q
U
I
R
E
D

OverEZ!
Assembly is Watch our assembly video here
Place FLOOR in desired location.
Important: Floor must be level
in both directions.
Find the bag with drill bits, keys,
and touch up paint (to repair any
mars on pre-painted surfaces).
Place BACK WALL (A), making sure
wall is tight against oor and ends
of wall line up with marks provided
on oor.
Drive 2 pre-started screws on the
bottom.
Place CHICKEN DOOR GABLE WALL (B).
Siding from BACK WALL will slide into
cavity provided. Make sure wall is
tight against oor.
Drive 2 pre-started screws on corners,
then drive 1 screw (provided in the
bag) into the pre-drilled hole into
side of door frame.
Install MAN DOOR GABLE WALL (D).
Siding from BACK WALL and FRONT
WALL will slide into cavities provided.
Make sure wall is tight against oor.
Drive 2 pre-started screws into back
corner, 1 pre-started screw through top
plate in upper front corner, then drive
1 screw (provided in the bag) into the
pre-drilled hole into side of door frame.
Install ROOF PANEL.
Lower front edge of ROOF PANEL onto
FRONT WALL rst, then lower back
edge onto BACK WALL.
step four
Place FRONT WALL (C), making sure
wall is tight against oor.
Siding from FRONT WALL will slide
into cavity provided in CHICKEN DOOR
GABLE WALL.
Drive 1 pre-started screw into gable
through top plate, then 2 pre-started
screws on bottom.
step three
step two
step one
step six
step ve
Put black screw in bottom hinge of
doors.
Drop ROOST BARS into slots provided
on inside of gable walls.
Hook CHICKEN RAMP at bottom of
chicken door.
step seven
NOTE: To loosen or tighten door latches, use supplied allen wrench.
Loosen small screw on inside of latch with allen wrench, moving the
latch in or out. Tighten screw and test.
Please note: Actual product may differ slightly from instructional illustrations.
Drive 4 pre-started screws through sheathing into gable.